Cascade Installation - Orion LED Flat Par Can Manuel Du Propriétaire

CASCADE INSTALLATION

The ORCAN3 provides a convenience outlet which can minimize wiring and improve overall safety when used
properly. Please carefully read all of the important safety tips shown below for long and safe use of your lighting
equipment.
IMPORTANT
1. Do not overload the convenience outlet. Make sure power drawn from the first outlet does not exceed the limits
shown on the chassis.
2. Always inspect the cords and plugs before use. Do not use outlets or cords that have exposed wiring, are worn
or damaged. Replace electrical cords that have worn or damaged insulation and remember to pull the plug, not
the cord to extend the life of the cord itself.
3. The AC supply cord should be routed so that it is unlikely that it will be damaged. Protect the power cord from
being walked on or pinched. If the AC supply cord is damaged DO NOT OPERATE THE UNIT. To completely
disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle. The
mains plug of the power supply cord shall remain readily operable. Unplug this apparatus during lightning storms
or when unused for long periods of time. Route cords away from traffic to avoid tripping hazards and unnecessary
wear on the power cord.
4. Never Break Off the Third Prong on a Plug. Replace broken 3-prong plugs and make sure the third prong is
properly grounded.
5. Keep line cords away from heat, water and oil. They can damage the insulation and create a shock hazard.
6. Do not tie cords in tight knots. Knots can cause short circuits and shocks. Loop the cords or use a twist lock
plug.
7. Be aware that unusually warm or hot outlets or cords may be a sign that an unsafe wiring condition exists.
Unplug any cords or extension cords from these outlets and do not use until a qualified electrician has checked
the wiring.
The AC power cords supplied purposefully have 2 blades and one grounding prong. If your outlet is not
equipped to handle this type of plug, do not attempt to forcefully plug this AC power cord into the outlet,
and do not alter the plug so that it can fit in the outlet. The only course of action you can take is to find
another outlet which is properly equipped to handle a grounded plug or have an electrician upgrade your
electrical outlet. Be sure that the plug is well connected so that it does not disconnect in the middle of
usage. If at any point in time the supplied AC power cord is punctured or damaged replace it with a new
power cord from a local electrician.
Always connect the fixture to a circuit with a suitable electrical ground.
To determine the power requirements for a particular fixture, see the label current rating at the ratings
plate of the fixture. A fixture's listed current rating indicates its average current draw under normal
conditions.
To ensure the convenience outlet is never overloaded follow thew following steps:
(a) Mark down the RATED INPUT current for all devices connected to the convenience
outlet.
(b) Calculate the sum of all of these currents to get the total current drawn from the outlet.
(c) Make sure this total current is less than the MAX current rating marked below the
outlet.
Keep in mind the MAX current is the power available from the very first convenience outlet.
15