Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATION
12V digital test panel with microprocessor for the
control of the voltage
(Ref.1)
consumed and supplied by the leisure battery
To turn on the backlight, lightly touch the "touch"
button
(Ref.3)
once, the backlight will remain on for 15
seconds.
In case some parts of the 12V equipment (lights, water
pump, ...) are switched on at the same time of a
NB: Amperometer maximum capacity 130A.
W
hen the backlight is off the system draws 0.0
CONNECTIONS
Remove the original cable from the leisure battery
negative pole
and connect it to the SHUNT free bolt.
Connect the SHUNT to the leisure battery negative pole
using the supplied
cable
(L=0.5m)
ATTENTION: Connect only to the leisure battery.
Pressing too hard to the "touch" button (Ref.3) can cause temporary marks on the display.
charging device (battery charger, solar panel, ...) the
and of the current
displayed value is the difference between the two
(Ref. 2)
.
currents.
E.g.:
connected battery charger:
switched on 12V equipment:
displayed value:
Connect the cable with 3A fuse to the leisure battery
to the battery).
(Ref.B)
.
Connect the PT
using the supplied cable (L=5m)
23
A.
pole (the fuse shall be placed as close as possible
65
2 test panel to the amperometer
EN
4A (charge)
3A (consumption)
1A (charge)
(Ref.A)
.
5
Publicité
