Dorman 926-867 Manuel D'instructions

INSTRUCTIONS
A/C HOSE
ASSEMBLY
926-867
1
3
4 5
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
926-867_Instructions
KIT CONTENTS
1 Front line sections (Qty: 4)
2 Middle line sections (Qty: 4)
3 Rear line sections (Qty: 4)
4 Side-mount clips (Qty: 4)
5 Center-mount clips (Qty: 6)
REMOVAL
INSTRUCTIONS
STEP 1:
Recover refrigerant from A/C system.
STEP 2:
Raise vehicle.
STEP 3:
2 Drain coolant.
STEP 4:
Remove passenger side front and rear
wheels and wheel well liners.
STEP 5:
Remove passenger side step.
STEP 6:
Disconnect high side and low side A/C lines
from mating lines in front passenger
wheel well.
STEP 7:
Lower vehicle.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 8:
Remove firewall shield.
STEP 9:
Disconnect two heater hoses from service
ports at the back of engine bay.
STEP 10:
Raise vehicle.
STEP 11:
Remove A/C lines from all clips.
STEP 12:
Disconnect rear A/C line connections from
expansion valve.
PAGE 1 OF 6