KLARBACH LE 66004 we Mode D'emploi page 25

b) Timer
b)Water pump-out function
Inside Drying
c) Ventilation levels
d) Humidity setting
e) AUTO mode
Continuous operation
f) On/Off button
g) Indicator light water pump-out function or inside drying
h) Indicator light ventilation levels
i) Indicator light condensate water tank full
j) Display indicator
l) Indicator light AUTO mode/continuous operation
Scope of delivery / components
• Set the time between 1 and 24 hours.
To deactivate the timer ahead of
time, press button "a" twice.
• Only the room air humidity which has
been set is illuminated on the display.
Water pump-out function:
When the device is in continuous
operation and is connected to a hose (9).
As soon as the condensate water tank is
full, the condensed water is pumped out.
Inside Drying:
Protective function against mould build-
up in the device.
Set the ventilation levels higher or lower
with the "c" button.
Humidity setting in % (shown in the
ranges of 30%-35%-40%-45%-50%-
55%-60%-65%-70%-75%-80%).
Setting only possible in AUTO mode.
Auto:
• If the room humidity is approx. 5%
higher than the set room humidity,
the device will start up as set.
• If the room humidity is between 5%
and -5%, the device starts in the
standard setting.
• If the room humidity is less than -5%,
the device starts with the fan and
without the compressor.
• Standard room humidity is 50%.
Continuous operation:
The device runs in continuous operation
independent of the room humidity.
Select high or low ventilation levels.
Switch off the device.
Page | 25