Tonino Lamborghini GBK 6100 LI TL Manuel D'utilisation page 21

e) Thoroughly maintain your power tool.
Check whether moving parts are work-
ing properly and are not jamming/
sticking, and whether parts are broken
or otherwise damaged in a way that
affects the function of the tool. Have
damaged parts repaired before using
the tool. Many accidents are the result of
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Thoroughly looked-after cutting tools with
sharp cutting edges are jamming less
often and are easier to guide.
g) Use power tools, accessories, add-on
tools, etc. in accordance with these
instructions and in the way prescribed
for the respective type of tool. You
should also consider the working con-
ditions and the work to be carried out.
The use of power tools for purposes other
than those intended for the respective
tool may result in dangerous situations.
5) Appropriate handling and use of battery-
operated power tools
a) Make sure that the device has been
switched off before inserting the bat-
tery. Inserting a battery into a switched-
on power tool may lead to accidents!
b) Only use charging devices recom-
mended by the manufacturer to charge
the batteries. Charging units are usually
designed for certain types of batteries;
if used with other types there is a risk
of fire!
c) Only use batteries designed for your
power tool. The use of other batteries
may lead to injury and risk of fire!
d) Keep unused batteries clear of paper
clips, coins,
other small metal objects
bridge the contacts. A short circuit be-
tween the battery contacts may lead to
burns or fire!
e) Improper use may result in fluid leak-
ing out of the battery. Avoid any con-
tact with battery fluid. Flush with water
in case of contact. If battery fluid
should get into your eyes seek medi-
cal advice additionally. Leaking battery
GB | Operating Instruction
keys, nails, screws or
that may
fluid may lead to irritations of the skin or
burns!
6) Service
a) Have the power tool serviced by quali-
fied technical personnel only; repairs
should be carried out using exclusive-
ly original spare parts. This will ensure
the safe operation of the power tool.
Safety instructions for grass- and shrub
shear:
Keep all parts of your body away from
-
the cutting blades. Do not try to remove
cut-off matter with the tool running. Do
not try to hold material to be cut off
with your hand. Remove cut-off matter
that is stuck between the blades only
with the tool being switched off! When
working with hedge trimmers even a short
moment of inattentiveness may result in
severe injury.
Carry the hedge trimmer at the handle
-
with the cutting blades standing still.
Always put on the protection cover when
transporting or storing the hedge trim-
mer. Careful handling reduces the risk of
injury through the cutting blades.
- Only hold the power tool on the insu-
lated handle surfaces, because the cut-
ting blade can come into contact with
concealed power lines. If the cutting blade
comes into contact with an energised line,
device parts can become energised and
cause an electric shock.
- Before starting work, search the hedge
for concealed objects, e.g. wire, etc. Pay
careful attention to ensure that the cutting
tool does not come into contact with wire or
other metal objects.
- Hold the power tool properly, e.g. with
both hands on the handles, if two han-
dles are present. Losing control of the
device can result in injuries.
Grass shears safety warning
• This product is not intended for use
by persons (including children) with re-
duced physical, sensory or mental capa-
bilities, or lack of experience and knowl-
4