PRO-POINT 8355331 Manuel D'utilisateur page 6

8355331
you hear the first click of the ratchet mechanism. Continue
until the terminal is held in place, but not compressed.
4. Slide the bare wire into the terminal and hold in place.
5. Squeeze the handles to compress the terminal until it is
fully collapsed around the wire.
6. Press the release lever (I) to open the jaws.
7. Remove the terminal and gently pull the wire to test if it is
secure. If it pulls free from the terminal, discard the terminal
and repeat with a new one.
A Insulated Terminal Jaw
B Non-Insulate Terminal
Jaws
C Open Barrel Terminal
Jaws
D Insulated Cord–End
Terminal Jaws
F Insulated Huge Cord-
End Terminal
H Open Barrel Terminal &
D-Sub V3.5 Jaws
6
7 PC QUICK CHANGE RATCHETING
WIRE TERMINAL CRIMPER KIT
For technical questions call 1-800-665-8685
AWG 22-18, 16-14, 12-10
mm 2 0.5–1.0, 1.5-2.5, 4.0-6.0
AWG 20-18, 16-14, 12-10, 8
mm 2 1.5, 2.5, 6.0, 10.0
AWG 20-18, 16-14, 12-10
2
mm 0.5–1.0, 1.5-2.5, 4.0-6.0
AWG 22, 20, 18, 16, 14, 12
mm 2 0.5, 0.75, 1.0, 1.5, 2.5, 4.0
AWG 10.0, 8.0, 6.0
mm 2 6.0, 10, 16
AWG 14, 22, 8.0-6.0
mm 2 2.5, 0.5, 8.0-10
V1.0
Table 1