Before Commissioning; Placing The System Into Operation - Elster Instromet SM-RI-X Manuel D'instruction

Turbine gas meter Instruction Manual

Before commissioning

Meters with oil pump must be initially lubricated.
Lubricate the meter as instructed in section Lubrication.

Placing the system into operation

To avoid damaging the meter, slowly fill the system. We advise using a bypass
with a maximum diameter of ¼DN. (See Fig.3 for details)
When fully pressurized perform a leak test.
Fig. 3 Bypass to avoid over speeding.
Elster-Instromet b.v.
Honeywell
Tel: +31 (0) 315 338911
Copyright © 2011 Elster.All rights
reserved.
www.elster-instromet.com
2.550.484 Rev. 2
ENG
11