Publicité
INSTRUCTION MANUAL:
LUCY-2
CAUTION: READ THE INSTRUCTIONS BEFORE USING THE APPLIANCE.
IMPORTANT:
Always shut off power to the circuit before starting installation work.
In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity
authority for advice.
INTRODUCTION
1.
Please read instructions before using this appliance.
2.
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and
injury.
3.
Clean Heat Shade thoroughly before and after each use following the cleaning instructions provided below.
4.
Turn off power at fused disconnect switch breaker and allow unit to cool before performing any adjustment, maintenance or
cleaning.
5.
Unit is not waterproof. Do not submerge the unit with water.
6.
This product should only be installed to the mains electricity supply by a qualified electrician. Failure to service by qualified
personnel may lead to electric shock or burn.
TECHNICAL SPECIFICATIONS
MODEL
LUCY-2
ELECTRICAL REQUIREMENTS
Plug the unit into a suitable power supply with correct voltage and sufficient power capacity. Refer to the product label (serial
plate) on the warmer for voltage and wattage requirements.
SAFETY INSTRUCTIONS
1.
Warning! All power must be disconnected at power source before any service procedure is performed.
2.
The unit is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as
drapes and other furnishings, away from the unit.
3.
Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left unattended.
4.
Always unplug the unit when not in use and before cleaning, adjusting or maintaining it. To disconnect appliance, turn switch
off and remove plug from power source.
5.
Do not operate the unit with a damaged cord or plug if the unit malfunctions, has been dropped, or damaged. Return the unit
to an authorized service facility for examination, electrical or mechanical adjustment, or repair.
6.
Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance where it may fall into
water.
7.
Connect to properly grounded outlets only. Avoid the use of extension cords. Do not run cord under carpeting, runners, or
leaks. Arrange cord away from traffic area and where it will not create a trip hazard.
8.
Installation must be conform to all local electrical codes. Failure to ground unit properly could result in serious personal injury
or death.
9.
To prevent a possible fire, it is recommended that the unit is placed on a non-combustible surface.
10. This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
3
VOLTAGE
POWER
230 V
0.25 kW
TÉL. : +33(0)4 72 23 23 98 FAX : +33(0)4 72 23 23 99
FREQUENCY
50/60 Hz
L2G SAS 17, AVENUE DU 24 AOÛT 1944
BP90690-69969 CORBAS CEDEX
POWER
BULB
CORD
1.2 M
BR40-230 V
Publicité
