Télécharger Imprimer la page

Liens rapides

PG9938/PG8938/PG4938
PowerG Panic Button Installation
Instructions
WARNING: CHOKING HAZARD!
Small parts. The pendant and belt clip are NOT for
children under 3 years.
Do not submerge the wireless key in any liquid as it
will damage the electronic circuits.
Keep this manual for future reference.
Operation
The PG9938/PG8938/PG4938 is a panic button. Confirmation
of a successful transmission is indicated by the LED light.
Device Setup
Enrollment
Refer to the PowerSeries Neo Host Installation
Manual or iotega Reference Manual for the
enrollment procedure.
Configuration
The following programmable option is available:
Supervision - Default [OFF]
Enables supervision of the device.
Assembly
Attaching to a Belt Clip
1. Slide the device into the holder until you feel it snap
securely inside.
2. To attach the belt clip, slide it onto the rails on the rear of the
holder.
Mounting
1. Align the holder on a wall facing up
as illustrated.
2. Using two #4 5/8" screws and
appropriate wall anchors, secure the
holder to the wall.
3. Slide the device into the holder until
you feel it snap securely inside.
4. To remove the device from the
holder, pinch the clasps.
Maintenance
Warning! Modifications to this device not expressly approved
by the party responsible for compliance may void the user's
authority to operate it.
Replacing the Battery
The required battery is CR2032 Lithium 3V, manufactured by
VARTA or Energizer, purchased from a DSC-approved sup-
plier. When this panic button is out of use, remove the battery
and dispose of them separately. Bring electrical appliances to
the local collecting points for waste electrical and electronic
equipment. Batteries are harmful to the environment, please
help to protect the environment from health risks.
Replace the battery at least once every 5 years, or upon observ-
ing that the LED flickers when transmitting.
WARNING: The polarity of the battery must be observed.
Improper handling of lithium batteries may result in heat gener-
ation, explosion or fire, which may lead to personal injuries.
WARNING: Replace only with the same or equivalent type
recommended by the manufacturer. Keep away from small chil-
dren. If batteries are swallowed, promptly see a doctor. Do not
try to recharge these batteries. Disposal of used batteries must
be made in accordance with the waste recovery and recycling
regulations in your area.
To replace the battery:
1. Insert a coin into the slot on the bottom of the unit and twist
it open.
D-307421
loading

Sommaire des Matières pour DSC PowerG PG9938

  • Page 1 Replacing the Battery The required battery is CR2032 Lithium 3V, manufactured by VARTA or Energizer, purchased from a DSC-approved sup- plier. When this panic button is out of use, remove the battery and dispose of them separately. Bring electrical appliances to the local collecting points for waste electrical and electronic equipment.
  • Page 2 Compatible Receivers This device can be used with DSC panels and receivers that use PowerG technology. For UL / ULC installations use these device only in conjunction with DSC wireless receivers: WS900-19, WS900-29, HSM2HOST9, HS2LCDRF(P)9, HS2ICNRF(P)9 and PG9920.
  • Page 3 Directive 2014/53/EU. The full text of the EU declarations of conformity for the models mentioned below are available at the following internet addresses: PG4938 - http://dsc.com/pdf/1401015 PG8938 - http://dsc.com/pdf/1401038 Frequency Band / Maximum Power g1 433.04MHz – 434.79MHz/10mW h1.4 868.0MHz –...

Ce manuel est également adapté pour:

Powerg pg8938Powerg pg4938