Monacor JTS JSS-20/5 Mode D'emploi page 12

Fig. 1 Menu
1. Frequency
2. Group/Channel
3. Sensitivity
4. Low Cut
5. Device ID
6. Remoset
7. RF Power
8. Contrast
9. Light Time
a. User Name
c. Reset
d. KeyLock
e. Exit
Overview
1 Top part of microphone with battery compart­
ment; seize the top part with one hand and the
lower part with the other hand and unscrew
the top from the bottom
2 Display, for details refer to chapter 3 3, Fig 3
3 LED indicator:
lighting in green = microphone switched on
flashing in red = microphone muted
lighting in red = batteries discharged
lighting in blue = settings are being transferred
from the receiver to the microphone via the
REMOSET function
4 Sliding cover to protect the control buttons
SET (7),  and  (8)
5 Cap to mark the microphone when multiple
microphones are used at the place of opera­
tion: The cap can be replaced by one of the
colour caps provided
12
1
1. 2.
2
LED
3
4
5
Fig. 2 JSS-20/5
7
8
6 Battery holder; to replace the batteries, fold
up the holder
7 Button SET to call up the setup menu in Fig 1
(keep the button pressed for 2 seconds until the
menu appears on the display) To call up a menu
item and to save a setting, refer to chapter 3 4
8 Arrow buttons  and  to select a menu item
and to change settings
9 Button to switch on /off, to mute the micro­
phone and to exit a menu/menu item
– To switch on, to mute / unmute the micro­
phone or to exit a menu (item), press the
button briefly
– To switch off, keep the button pressed for
2 seconds until the display indicates
OFF
10 Colour­coded ID ring supplied
(also refer to item 5)
6
Power
9
10