Reznor CD9 Installation

DUCT FLANGE KIT INSTALLATION FOR BLOWER-TYPE
GAS-FIRED UNIT HEATERS
OPTION CD9 FOR MODEL UBXC AND OBSOLETE MODELS UBX AND UBZ
• This duct flange option is designed for connecting blower-type unit heaters to warm air ductwork.
• Refer to the installation manual provided with the heater for important safety information.
• Ensure that all components listed in
dimensions of the duct flange assembly.
Component
Duct flange, top/bottom
Duct flange, side
Screw, duct flange
Screw, #10, sheet metal, self-tapping
Dimension 30, 45
Width
Height 13-3/8 (339)
Install the duct flange kit (see
SIDE DUCT FLANGE
SELF-TAPPING SHEET
METAL SCREW(S)
TOP/BOTTOM DUCT FLANGE
Figure 1. Face Plate Assembly with Duct Flange Assembly (Typical)
DO NOT DESTROY. PLEASE READ CAREFULLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
KIT COMPONENTS
Table 1
are available before beginning installation. Refer to
Table 1. Kit Components
30, 45 60, 75
1036350 1036351
1034655 (2) 1034655 (2)
1034657 (2) 1034658 (2)
Table 2. Duct Flange Dimensions
60, 75 100, 125
17-1/8 (435)
16-3/8 (415) 24-3/8 (618)
INSTALLATION
Figure 1) as follows:
Revision: UBXC-CD9 (02-25) 1036171-E
Supersedes: UBXC-CD9 (11-24) 1036171-D
Unit Size (MBTUh)
100, 125 150, 175, 200
Kit PN
1036352 1036353
Component PN (Quantity)
1034655 (2) 1034656 (2)
1034659 (2) 1034660 (2)
11813 (as required)
37661 (as required)
Unit Size (MBTUh)
150, 175, 200
Inches (mm)
19-1/2 (496)
Table 2
225, 250 300, 350, 400
1036354 1036355
1034656 (2) 1034656 (2)
1034661 (2) 1034662 (2)
225, 250 300, 350, 400
26-7/16 (672)
25-1/2 (648) 33-1/2 (852)
FACE PLATE
DUCT FLANGE SCREW
for