Publicité
REGULATORY STATEMENTS
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
This device complies with the FCC/ISED RF exposure limits and has been evaluated in compliance with portable exposure condition.
To comply with the SAR testing exclusion, the equipment must be installed and operated with a minimum distance of 15 mm of the human body.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and with Industry Canada Licen-
se-exempt RSS standard(s).
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one ormore of the followingmeasures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ROTOR has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user's authority to operate the equipment.
Repairs should only be made by ROTOR distributors. Unauthorized repairs could result in permanent damage to the equipment and void your warranty.
This device complies with the FCC/ISED RF exposure limits and has been evaluated in compliance with portable exposure condition.
To comply with the SAR testing exclusion, the equipment must be installed and operated with a minimum distance of 15 mm of the human body.
CEE REGULATION
ROTOR declares that the radio equipment type INspider is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: http://rotorbike.com/
ROTOR RPM2
FCC ID: R3AROT118
IC: 10992A-ROT118
12
Publicité
