Cleaning And Maintenance; Remplissage Du Réservoir D'eau - Oceanic OCEAVB100W1 Guide D'utilisation

Cleaning and Maintenance

- Always turn off and unplug the appliance from the mains socket before
cleaning.
- It is recommended that you clean the water tank every 3 days and clean the
flume every week.
- Once the fan guard was assembled, it is forbidden to take off the guards
when cleaning.
- Clean the fan with a slightly damp cloth, and then dry it.
- Do not immerse the motor housing in water or any other liquid.
- Do not use chemical or abrasive cleaner.
- Pull out the water tank before cleaning it - pull the plastic tube out of the mist
cask properly, then take out the mist cask and water tank.
-
Use a dry cloth to clean the mist cask. If there are stubborn stains on the mist
cask, use a cloth lightly dampened with mild detergent.
- If the mist feature will not be used for a long time, empty the water tank and
leave it to dry before recapping it.
Troubleshooting
Fault Phenomenon Reason
a. Clean out the water tank and
a. Water could be
2. Mist projector replace with clean water
contaminated with other
works normally, b. Pour out the water and check for
substances or chemicals
but without mist cracks
b. Water tank could be cracked
spray c. Refill the water tank. A full tank of
c. Water tank could be empty
water will last approximately 8 hours
a. Free the bobber and allow it to
a. Bobber doesn't float
2. Mist projector float freely.
doesn't work
b. Water tank could be empty b. Refill the water tank. A full tank of
water will last approximately 8 hours
3. No indicator light, a. Power cord is unplugged, a. Plug the power cord, and turn on
no wind, no mist. and electric power is power off the electric power
a. When new, there might be
a. The smell should disappear after
residue in the water tank/mist
4.Peculiar smell from further use.
plate.
the mist b. Clean out the water tank and refill
b. The water in the water tank
with fresh water
many be contaminated.
a. Find service agent or a suitable
a. The plug and supply cord are qualified person to change or
service b. Don't play the blades.
damaged
5.The fan doesn't
b. The blades are bend Use soft damp cloth then wipe with
work as normal
c. Don't safety device
dry cloth
c. Installed correctly in accordance
with the manual.
Remplissage du réservoir d'eau
Placez le ventilateur sur un sol plat et stable, puis ajoutez de l'eau pour la fonction
d'humidification comme suit :
1. Ouvrez le couvercle du
réservoir d'eau.
Solution
4. Retournez le réservoir
d'eau sur un évier
2. Soulevez le réservoir d'eau 3. Retirez avec précaution le
jusqu'à ce qu'il se détache du réservoir d'eau de l'appareil.
ventilateur.
OUVRIR FERMER
5. Dévissez le couvercle et 6. Remettez
remplissez le réservoir avec de soigneusement le
l'eau propre. Remettez le réservoir d'eau sur
couvercle en place et serrez-le l'appareil. Rassurez-vous
bien. qu'il est bien en place pour
éviter les fuites.