Publicité
Temperature and serial number display: Normally it displays the room temperature; while
setting the temperature, the setting temperature is displayed; When setting the timer, serial
number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting the timer, the
setting time is displayed. When setting the temperature of the week timer, the setting
temperature is displayed.
Time on and time off: It is displayed while setting the timer, and it is used in combination with
serial number setting.
Flame brightness: It displays the current brightness of the flame, which ranges from one to five
positions.
Manual Operation
This is done by operating the switches located at the top right hand side of the fire .The
standby rocker switch must first be switched on, the fire will beep to indicate that it is powered
up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show
to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the dimmer
mode, hold the button down until the desired brightness is obtained.
820-052,02-0357:
Press the POWER button once for the low heat setting 1000W;
Press twice for the high heat setting 2000W;
Press three to switch off the heat setting.
820-053,02-0358:
Press the POWER button once for the low heat setting 900W;
Press twice for the high heat setting 1800W;
Press three to switch off the heat setting.
Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be switched
on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons more
than once within two seconds for the fire to operate normally.
1. Boot steps
1) Connect the power
2) Turn on the power switch
3) Press the control switch or "ON/OFF" key of the remote controller to start up
4) 820-052,02-0357: Press the 1000W/2000W button once for the low heat setting 1000W;
press twice for the high heat setting 2000W; press three to switch off the heat setting.
820-053,02-0358: Press the 900W/1800W button once for the low heat setting 900W; press
twice for the high heat setting 1800W; press three to switch off the heat setting.
5) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and lower
the brightness.
6) Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
2. Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heating.
6
Publicité
