Publicité
Height-Adjustable Products – Expansion Series / Produits réglables en hauteur - Série Expansion
User Guide / Guide d'utilisation
To store a position :
• Drive to the required desk height
• Press the "S" button.
• Press a memory button (•, •• ou •••).
To drive to a stored height :
• Press and hold a memory button. The surface will
stop at the stored position.
Reinitialize the system when :
• the system does not operate properly, move slowly &/or only downward.
• the desk has been moved &/or relocated.
• an actuator (leg) looses its connection to the control box or a connecting cable is pulled out during operation.
• the table impacts an obstruction during operation - more than once. Make sure there are no obstructions in either the up or down directions and carry out
a reinitialization
• the display shows error code E##.
If a reinitialization does not address the issue, contact your facilities representative for assistance.
For additional information on this installation contact Technical Support. Pour plus d'informations sur cette installation contactez le support technique.
2021-05-26
• Not Applicable
L04-64035_R02.DOCX
To store a position :
• Drive to the required desk height
• Press the "star" button until desired memory
number is displayed
• Press the "star" button for two seconds to store
position
To drive to a stored height :
• Tilt and hold the panel. The surface will stop at
the stored position.
To reset all memory positions :
• Press the "star" button 5 times so the "no
memory" logo is displayed.
•Press the "star" button for two seconds to confirm.
• For "reminder" function and Bluetooth® pairing
instructions, Press the "reminder" (clock) button
and scan the QR code displayed or refer to
Teknion web site.
5 / 10
Publicité
