Publicité
2. Pull out the filter as shown below.
3. Cleaning should be done by removing all dust deposits with a vacuum
cleaner and then by washing in warm water using a neutral, non-
aggressive detergent.
4. Once cleaned, allow the filter to dry completely.
5. Refit the filter on the unit by following the previous steps in reverse
order. Make sure to leave the filter tabs visible (do not insert them into
the upper black guide).
12 .2 Checking for the presence of air in the system
It is advisable to periodically check the air flow inside the system circuit
to ensure that the unit always operates correctly. If necessary, vent as
indicated in paragraph 7.4.
12 .3 Drainage
In case of prolonged inactivity, it is advisable to drain the unit.
Cod. 1910000000085 - nv03
DECLARATION OF CONFORMITY
The company Cordivari S.r.l., with registered office in Zona Industriale
Pagliare, Morro d'Oro (TE), Italy, declares under its own responsibility
that the fan coils referred to in para. 2 comply with the following standards:
EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017 + A1:2019 +
A14:2019 + A2:2019 + A15:2021 + A16:2023
EN IEC 60335-2-40:2023 + A11:2023
EN 62233:2008 + AC:2008
EN IEC 61000-3-2:2019 + A1:2021
EN 61000-3-3:2013 + A1:2019 + A2:2021
EN IEC 55014-1:2021
EN IEC 55014-2:2021
ETSI EN 301 489-1 (V2.2.3)
Draft ETSI EN 301 489-17 (V3.2.6)
Health assessment according to EN 62311:2020
and therefore comply with the essential requirements of European
Directives:
Directive 2014/53/EU
Directive 2014/35/EU
Directive 2014/30/EU
Directive 2012/19/EU
Directive 2009/125/EC
Directive 2011/65/EU amended by 2015/863/EU and 2017/2102/EU
Commission Regulation (EU) 2016/2281
Morro D'Oro, 01/07/2024
- 25 -
Cav. Ercole Cordivari
Amministratore unico
English
Publicité
