clage Zip HydroTap G5 BC 20 Instructions D'utilisation page 35

LCD Screen Operation - Section B
Boiling calibration
The boiling point calibration is
started automatically during
initial commissioning and can be
repeated manually here. One run
takes approx. 10 minutes.
Note: Hot steam may escape from the fitting during calibration!
Booster
This function should only be
considered when a Booster unit is
installed.
Note: Failing to make the correct
selection for 'Booster' will effect
product performance.
III. Dispense Times
For all taps with a filling function
DISPENSE TIMES 12:12 PM
and for each type of water, a
duration of 5 - 15 seconds can be
Boiling Chilled
set here for automatic dispensing.
14 07
SEC SEC
35