Page 1
Finally. A reason to use coasters. Side Table NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. Morgan Main Collection | Model 433736 PLEASE READ AND KEEP FOR FUTURE REFERENCE. English pg 1-22 Français pg 23-25 Scan to rate and review Español pg 26-28...
Page 2
Table of Contents Assembly Tools Required Part Identification No. 2 Phillips Screwdriver Hardware Identification Tip Shown Actual Size Hardware Usage Guide Assembly Steps 6-22 Français 23-25 Español 26-28 Safety 29-30 Warranty Page 2 www.sauder.com/service 433736...
DRAWER BACK (2) BOTTOM (1) SHORT BOTTOM BRACE (2) LEFT DRAWER SIDE (2) LEFT END (1) LONG BOTTOM BRACE (2) RIGHT DRAWER SIDE (2) RIGHT END (1) DRAWER FRONT (2) DRAWER BRACE (2) BRACE (1) DRAWER BOTTOM (2) 433736 www.sauder.com/service Page 3...
Page 4
CAM SCREW - 28 LARGE WOOD SMALL WOOD PULL - 2 APPLIQUE CARD - 1 DOWEL - 16 DOWEL - 10 1-9/16" PAN HEAD SCREW - 4 1-3/16" FLAT HEAD SCREW - 8 1/2" FLAT HEAD SCREW - 20 Page 4 www.sauder.com/service 433736...
Page 5
The arrow in the HIDDEN CAM must point Arrow toward the hole in the edge of the board. Hidden Cam Hole Insert the CAM SCREW or CAM DOWEL into the HIDDEN CAM. Tighten the HIDDEN CAM. 433736 www.sauder.com/service Page 5...
Page 6
Step 1 Look for this icon. It means a video assembly tip is available at www.sauder.com/service/tips Find the numbered video or scan the QR code. å Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
Page 7
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS. 1/2" FLAT HEAD SCREW (8 used in this step) Open end Push the black lever in and pull the SLIDE from the RAIL. Open end Open end 433736 www.sauder.com/service Page 7...
Page 8
HIDDEN CAM. å NOTE: Be sure the LARGE WOOD DOWELS in the BRACE insert into the ENDS. Open end Arrow D E N H I D i t h f a c S u r Open end Page 8 www.sauder.com/service 433736...
Page 9
å Fasten the TOP (A) to the ENDS (C and D). Tighten four HIDDEN CAMS. å NOTE: Be sure the LARGE WOOD DOWELS in the ENDS insert into the TOP. These holes must be here. 433736 www.sauder.com/service Page 9...
Page 10
Step 5 å Insert ten SMALL WOOD DOWELS (6) into the BACKS (H). å Push the BACKS (H) together. Page 10 www.sauder.com/service 433736...
Page 11
Step 6 å Insert the BACKS (H) into the TOP (A). å NOTE: Be sure the WOOD DOWELS in the BACKS insert into the TOP. 433736 www.sauder.com/service Page 11...
Page 12
NOTE: Be sure the WOOD DOWELS in the BACKS and ENDS insert into the BOTTOM. o l e r e h i t h f a c S u r 1-9/16" PAN HEAD SCREW (4 used in this step) Page 12 www.sauder.com/service 433736...
Page 13
Step 8 å Carefully turn your unit onto its top. å Turn six CAM SCREWS (4) into the exact holes shown in the BOTTOM (B). 433736 www.sauder.com/service Page 13...
Page 14
Fasten the remaining LONG BOTTOM BRACE (K) to the SHORT BOTTOM BRACES (J). Tighten two HIDDEN CAMS. Arrow (4 used) (10 used) Arrow Unfinished edge Arrow Surface with HIDDEN CAMS Unfinished edge Surface without HIDDEN CAMS Page 14 www.sauder.com/service 433736...
Page 15
Insert six LARGE WOOD DOWELS (5) into the BOTTOM (B). Now might be a å Fasten the BOTTOM BRACES (J and K) to the BOTTOM (B). good time to refresh Tighten six HIDDEN CAMS. your drink. 433736 www.sauder.com/service Page 15...
Page 16
Turn six CAM SCREWS (4) into the exact holes shown in one each of the DRAWER FRONTS (L) and DRAWER BACKS (P). å Push six HIDDEN CAMS (3) into one each of the DRAWER SIDES (Q and R) and DRAWER BRACES (T). Arrow Arrow Page 16 www.sauder.com/service 433736...
Page 17
BACK (P). Use four 1-3/16" FLAT HEAD SCREWS (10). å Fasten the DRAWER BRACE (T) to the DRAWER BACK (P). Tighten one HIDDEN CAM. Groove The HIDDEN CAMS must be here. Groove 1-3/16" FLAT HEAD SCREW (4 used in this step) 433736 www.sauder.com/service Page 17...
Page 18
Insert one LARGE WOOD DOWEL (5) into the DRAWER BRACE (T). å Fasten the DRAWER FRONT (L) to the DRAWER SIDES (Q and R) and DRAWER BRACE (T). Tighten five HIDDEN CAMS. i s h fi n r f a Page 18 www.sauder.com/service 433736...
Page 19
Fasten the EXTENSION SLIDES (2) to the DRAWER SIDES (Q and R). Use four 1/2" FLAT HEAD SCREWS (11) through holes #1 and #3. Open end Open end 1/2" FLAT HEAD SCREW (4 used in this step) 433736 www.sauder.com/service Page 19...
Page 20
Fasten a PULL (7) to the DRAWER FRONT (L). Use two 1/2" FLAT HEAD SCREWS (11). Almost time to å Repeat steps 11-15 for the other DRAWER. celebrate! With a nap. 1/2" FLAT HEAD SCREW (2 used in this step) Page 20 www.sauder.com/service 433736...
Page 21
EXTENSION RAILS on the unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way in, then it will slide in and out easier. Extension Rail Inner cartridge 433736 www.sauder.com/service Page 21...
Page 22
NOTE: Please read the back pages of the instruction booklet for important safety information. å This completes assembly. Clean with a damp cloth. Wipe dry. 25 lbs. 25 lbs. Scan to rate and review your piece at Sauder.com Your opinion matters! Page 22 www.sauder.com/service 433736...
Modèle 433736 Table d’ a ppoint Utilisez les instructions d’ a ssemblage en français avec les NOUS CONTACTER EN PREMIER schémas étape par étape du manuel d’instruction en anglais. AVANT D'EFFECTUER TOUT RETOUR AU MAGASIN. Chaque étape en français correspond à la même étape en Nous faisons de notre mieux pour nous assurer que votre meuble anglais.
Fixer l’ENTRETOISE (G) à l'EXTRÉMITÉ DROITE (D). Serrer un EXCENTRIQUE ESCAMOTABLE. Fixer l'EXTRÉMITÉ GAUCHE (C) à l’ENTRETOISE (G). Serrer un EXCENTRIQUE ESCAMOTABLE. REMARQUE: S’ a ssurer d’insérer les GRANDES CHEVILLES EN BOIS de l’ENTRETOISE dans les EXTRÉMITÉS. Page 24 www.sauder.com/service 433736...
Décoller les APPLIQUÉS des FICHES D'APPLIQUÉS (8) et coller les sur chaque EXCENTRIQUE ESCAMOTABLE visible. REMARQUE: Prière de lire les informations importantes sur la sécurité figurant sur les pages arrière du manuel d’instructions. Ceci complète l'assemblage. Nettoyer avec un tissu humide. Essuyer. 433736 www.sauder.com/service Page 25...
PANEL SUPERIOR ............1 (JUEGO DE EXTENSIÓN SE MUESTRA POR su referencia futura. Si SEPARADO) necesita ponerse en FONDO .................1 contacto con Sauder en RIEL DE EXTENSIÓN ..........4 EXTREMO IZQUIERDO ..........1 cuanto a esta unidad, CORREDERA DE EXTENSIÓN ......4 EXTREMO DERECHO ..........1 refiérase al número...
Page 27
Fije la RIOSTRA (G) al EXTREMO DERECHO (D). Apriete un EXCÉNTRICO ESCONDIDO. Fije el EXTREMO IZQUIERDO (C) a la RIOSTRA (G). Apriete un EXCÉNTRICO ESCONDIDO. NOTA: Asegúrese de que los PASADORES DE MADERA GRANDES en la RIOSTRA se inserten en los EXTREMOS. 433736 www.sauder.com/service Page 27...
Page 28
Fije la RIOSTRA DE CAJÓN (T) al DORSO DE CAJÓN (P). Apriete Esto completa el ensamblaje. Limpiar con un trapo húmedo. un EXCÉNTRICO ESCONDIDO. Seque con un paño. Page 28 www.sauder.com/service 433736...
Page 29
à mortelles. Les téléviseurs peuvent être un téléviseur. cet effet. particulièrement lourds. De plus, le poids et l’emplacement du tube image ont tendance à rendre les téléviseurs instables et enclins à tomber vers l’ a vant. 433736 www.sauder.com/service Page 29...
Page 30
Además, el peso y la ubicación del tubo de imagen tienden a causar la inestabilidad de televisores y son propensos a inclinarse hacia adelante. Page 30 www.sauder.com/service 433736...
à compter de la date d'achat la première fois et qui sont signalés à Sauder dans les limites de couverture de la contre tout défaut de matériaux ou de fabrication des composantes de mobilier Sauder.
Page 32
CONTACT US FIRST BEFORE MAKING ANY RETURNS TO THE RETAILER. Dear Valued Customer: Register and review Thanks so much for choosing Sauder® furniture. I hope the your new product purchase and assembly process was a positive experience at Sauder.com and you feel good about the furniture you just built.