Current LED172G11/830 Mode D'emploi

High Lumen Biax Type A
LED Replacement Lamp
BEFORE YOU BEGIN
Read these instructions completely and carefully.
For your safety read and observe all CAUTIONS and
WARNINGS shown throughout these instructions.
• Installation to be performed by trained or qualified personnel. Ensure this manual is provided to the installers and users.
• Use this product only in the manner intended by the manufacturer. If there are any questions or concerns, contact the manufacturer.
• The product is designed for indoor application only, and should not be used in environment of high temperature and high humidity.
• The product is not intended for use with Emergency lighting.
• Suitable for dry/damp locations.
RISK OF FIRE OR ELECTRIC SHOCK - Disconnect power before installation or maintenance. Contact a
qualified electrician for installation if needed. This lamp only operates on electronic ballasts. If the lamp does
not light when the luminaire is energized, remove lamp from luminaire and contact lamp manufacturer or
qualified electrician. Suitable for Damp locations.
RISK OF FIRE - If the lamp or luminaire exhibits undesirable operation (buzzing, flickering, etc.). immediately
turn off power, remove lamp from luminaire and contact manufacturer. Do not install this lamp in a pre-heat
luminaire. Direct replacement for 40W/22TS/T/2G11/RS lamps only. Use only in place of fluorescent lamps
specified on label.
Provided Components
The components have been properly packed to avoid damage during transit. Inspect the components to confirm there is no physical damage.
Do not install damaged components. The carton consists of: 1. LED tubes & 2. Installation guide
Installation Instructions
1. Ensure that the power to the unit
is turned off. Use proper Lock Out
and Tag Out procedures.
Maintenance/Lamp Replacement
Contact a qualified electrician for maintenance service. For any questions or concerns contact the manufacturer.
Compatible Ballast List
Please refer to: www.LED.com/LED2G11-compatibility
Note: Contact a Current sales representative if the ballast to be used to operate the lamp is not listed in the table.
This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. This device complies with CAN
ICES-005A.
NOTE: This product complies with Part 18 of the FCC Rules but may cause interference to radios, televisions, wireless telephones, and remote controls.
Avoid placing this product near these devices. If interference occurs, move the product away from the device or plug either into a different outlet. Do
not install this product near maritime safety equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.
Save these instructions
These instructions do not purport to cover all details or variations in components
nor to provide for every possible contingency to be met with respect to installation,
operation or maintenance. Should further information be desired or should particular
problems arise which are not covered sufficiently for the purchaser's purpose,
the matter should be referred to Current. Current does not claim liability for any
installation not performed according to this guide or not by a qualified electrician.
WARNING
CAUTION
2. Remove existing lamps
and fixture cover plate
from the luminaire.
www.LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information and specifications subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
Installation Guide LEDL094 | A-1028168
3. lnsert the LED tube
into the lamp holder and
engage tube into clip.
LED172G11/830
LED172G11/835
LED172G11/840
LED172G11/850
4. Restore the power supply
and make sure lamps are
operating correctly.
Page 1 of 2
(Rev 06/02/23)
LEDL094_R01