Uline H-1034 Instructions D'installation

H-1034, H-1187
PORTABLE ROLL STAND
TOOL NEEDED
Phillips Screwdriver
B
G
F
1. Attach two connector bars (E) to leg assemblies
(A and B) using screws (G). (See Figure 1)
Figure 1
2. Loosen outside screws on feed clamp (C), and slide
feed clamp into top leg assembly tubes (A and B).
Tighten screws to secure. (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
C
H
D
G
E
G
E
PARTS
A
REF. QTY.
A 1
B 1
C 1
D 1
E 2
G
F 2
G 4
H 1
ASSEMBLY
3. Slide axle (D) into holder on assembly legs.
(See Figure 3)
Figure 3
4. Load packaging material on the stand unspooling
from the outside.
5. Adjust I-bolt on top of the feed clamp to packaging
material thickness. Feed packaging material through
the feed clamp from back to front. Tear material at
the perforation or run a knife through the cutting
surface channel to cut material to size. (See Figure 4)
Figure 4
Para Español, vea página 2.
Pour le français, consulter la page 3.
DESCRIPTION
Leg Assembly With Handle
Leg Assembly Without Handle
Feed Clamp
Axle
Connector Bar
Caster
Screw
Cutting Surface
I-Bolt
Cutting Surface Channel
0221 IH-1034