Ktech FS801 Instructions D'installation

Ktech
INDUSTRIAL PRODUCTS INC.
Model FS801 Overfill Protection Device Installation Instructions
Part No.: FS801-4-NB
CAUTION: REFER TO INSTRUCTIONS BEFORE OPERATING OR SERVICING SWITCH.
Construction:
5/16" O.D. ss stem, 1" dia. 316 ss float.
Switch set-point distances are measured from the bottom to the center of the float at the level
where the switch is activated. Switch set-point distances are not field adjustable. They are
factory-set as specified on the purchase order. The contact arrangement may be changed
from normally open (NO) to normally closed (NC) and vice versa. Turn over the float and
return the stop collars to their original positions. If the contact arrangement is altered, use an
ohmmeter to test that the switch operates correctly. The conductors are colour coded to
identify each switch. The switch must be connected in series with a load.
DO NOT CONNECT THE SWITCH DIRECTLY ACROSS THE POWER SUPPLY.
The voltage / current product must not exceed the power rating.
Electrical Specifications
Maximum Switching Voltage
Volts DC/AC
Maximum Switching Current
Amps DC/AC
Maximum Switching Power
Volt/Amps DC/AC
Operating Temperature
Range
48"
S.P. "A"
S.P. "B"
S.P. "C"
Ktech Industrial Products, 20 Regan Road, Unit 11, Brampton, Ontario. L7A 1C3
120
0.4
50
o o
-25 C to 125 C
o o
-13 F to 257 F
NO
NO
NO
NO
S.P. "D"
1" dia. X 1.2" long
316 SS Float
LISTED
OVERFILL
PROTECTION
DEVICES
4YC9
Meets Standards:
Class 1 Division 1, Groups B,C,D
CSA C22.2 No. 1010-1 and ANSI/I SA S82-03
CSA C22.2 No. 30 and UL1203
Factory Sealed
MINIMUM SETPOINT DISTANCE FROM TOP IS 1"
MINIMUM SETPOINT DISTANCE BETWEEN CONTACTS IS 2"
MINIMUM SETPOINT DISTANCE FROM BOTTOM IS 1 1/2"
22 Awg Wires
POWER
SUPPLY
FLOAT
SWITCH
"A"
FLOAT
SWITCH
"B"
FLOAT
SWITCH
"C"
FLOAT
SWITCH
"D"
FLOAT
SWITCH
LOAD
BLACK
"A" = 26"
BLACK
WHITE
"B" = 18"
WHITE
RED
"C" = 10"
RED
GREEN
"D" = 2"
GREEN
Phone (905) 840-7106, Fax (905) 840-6172
N.O.
N.C.
N.O.
N.C.
N.O.
N.C.
N.O.
N.C.