Télécharger Imprimer la page

Green Creative 15T8/4F/8CCTS/EM Guide Rapide

Publicité

Liens rapides

IMPORTANT SAFE GUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS
GARANTIES IMPORTANTESLISEZ ET SUIVEZ TOUTES LES INSTRUCTIONS DE SÉCURITÉ
When using electrical equipment, basic safety precautions should always be followed including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A REFRIGERATION SYSTEM WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY
AUTHORITIES HAVING JURISDICTION.
Lors de l'utilisation d'un équipement électrique, des précautions de sécurité de base doivent toujours être suivies, notamment :
CE PRODUIT DOIT ÊTRE INSTALLÉ CONFORMÉMENT AU CODE D'INSTALLATION APPLICABLE PAR UNE PERSONNE FAMILIERE AVEC LA CONSTRUCTION ET LE
FONCTIONNEMENT DU PRODUIT ET LES DANGERS IMPLIQUÉS.THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A REFRIGERATION SYSTEM WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY
AUTHORITIES HAVING JURISDICTION.
WARNING - Read all product labels and instructions before installation.
WARNING - Turn off power before installation, inspection or removal.
WARNING - Installation and servicing should be done by qualified personnel only in accordance with the National Electrical Code and local regulations. De-energize before
opening.
WARNING - This unit provides more than one power supply connection point. To reduce the risk of electrical shock, disconnect both normal and emergency sources by
turning off the A.C. branch circuit and by disconnecting the unit connector before servicing.
WARNING - Sealed unit. Battery not replaceable. Replace entire unit when necessary.
WARNING - This unit requires an unswitched power source of 120-277VAC, 50-60Hz.
Electricians or end-users must confirm system compatibility before final installation.
Operates in emergency mode for 90 minutes.
24-hour recharge time.
Do not use outdoors.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than its intended use.
The Emergency LED Tube is intended for ordinary locations and for permanent installation into one or more Listed luminaires.
WARNING - Risk of fire or electric shock. LED Reflector kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation.
Contact a qualified electrician.
WARNING - Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings
and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
WARNING - Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING - To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
WARNING - To avoid potential fire or shock hazard, do not use this retrofit kit in luminaires employing shunted bi-pin lampholders. Note: Shunted lamp holders are found
only in fluorescent luminaires with Instant-Start ballasts. Instant-start ballasts can be identified by the words "Instant Start" or "I.S." marked on the ballast.
This designation may be in the form of a statement pertaining to the ballast itself, or may be combined with the marking for the lamps with which the ballast is
intended to be used, for example F40T12/IS. For more information, contact the LED luminaire retrofit kit manufacturer.
WARNING - Installers should not disconnect existing wires from lampholder terminals to make new connections at lampholder terminals. Instead installers should cut
existing lampholder leads away from the lampholder and make new electrical connections to lampholder lead wires by employing applicable connectors.
WARNING - Examine all parts that are not intended to be replaced by the retrofit kit for damage and replace any damaged parts prior to installation of the retrofit kit.
WARNING - TYPE B LAMP - Intended for operation in luminaires with traditional fluorescent-type lampholders wired directly to the branch circuit. This includes both
factory-wired luminaires as well as those converted for this purpose under a retrofit program.
CAUTION - Device has to be checked and re-activated to keep emergency function after installation.
INSTALLATION D'URGENCE T8 CCT SELECT - AVERTISSEMENT
WARNING - Lisez toutes les étiquettes et instructions du produit avant l'installation.
WARNING - Coupez l'alimentation avant l'installation, l'inspection ou le retrait.
WARNING - L'installation et l'entretien doivent être effectués uniquement par du personnel qualifié, conformément au Code national de l'électricité et aux réglementations
locales.Mettre hors tension avant ouverture.
WARNING - Cette unité fournit plus d'un point de connexion d'alimentation électrique. Pour réduire le risque de choc électrique, débranchez les sources normales et
d'urgence en éteignant le circuit de dérivation CA et en débranchant le connecteur de l'unité avant l'entretien.
WARNING - Unité scellée. Batterie non remplaçable. Remplacer l'ensemble de l'unité si nécessaire.
WARNING - Cet appareil nécessite une source d'alimentation non commutée de 120-277 VCA, 50-60 Hz.
Les électriciens ou les utilisateurs finaux doivent confirmer la compatibilité du système avant l'installation finale.
Fonctionne en mode d'urgence pendant 90 minutes.
Temps de recharge de 24 heures.
Ne pas utiliser à l'extérieur.
Ne pas installer à proximité de radiateurs à gaz ou électriques.
L'équipement doit être monté dans des endroits et à des hauteurs où il ne sera pas soumis à des manipulations par du personnel non autorisé.
L'utilisation d'équipements accessoires non recommandés par le fabricant peut entraîner une situation dangereuse.
N'utilisez pas cet équipement à d'autres fins que celles auxquelles il est destiné.
Le tube LED d'urgence est destiné aux emplacements ordinaires et à une installation permanente dans un ou plusieurs luminaires répertoriés.
www.greencreative.com - info@greencreative.com - Tel / Fax: (866) 774-5433 -
CCT SELECT EMERGENCY T8 INSTALLATION - WARNING
For model #: 15T8/4F/8CCTS/EM
Pour les produits suivants: 15T8/4F/8CCTS/EM
/ GREENCREATIVELED
/ GClightingLED
/ GREEN-CREATIVE
An ILLUMUS Brand

Publicité

loading

Sommaire des Matières pour Green Creative 15T8/4F/8CCTS/EM

  • Page 1 For model #: 15T8/4F/8CCTS/EM Pour les produits suivants: 15T8/4F/8CCTS/EM IMPORTANT SAFE GUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS GARANTIES IMPORTANTESLISEZ ET SUIVEZ TOUTES LES INSTRUCTIONS DE SÉCURITÉ When using electrical equipment, basic safety precautions should always be followed including the following: THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
  • Page 2 For model #: 15T8/4F/8CCTS/EM Pour les produits suivants: 15T8/4F/8CCTS/EM INSTALLATION D'URGENCE T8 CCT SELECT - AVERTISSEMENT WARNING - Risque d'incendie ou d'électrocution. L'installation du kit Réflecteur LED nécessite une connaissance des systèmes électriques des luminaires. Si vous n'êtes pas qualifié, ne tentez pas l'installation. Contactez un électricien qualifié.
  • Page 3 For model #: 15T8/4F/8CCTS/EM Pour les produits suivants: 15T8/4F/8CCTS/EM CCT SELECT EMERGENCY T8 INSTALLATION / CCT SELECT INSTALLATION D'URGENCE T8 fig.6 LED tube wiring diagram without dimming WALL SWITCH UNSWITCHED LINE SWITCHED LINE AC 120-277V AC 120-277V NEUTRAL NEUTRAL Testing Button...

Ce manuel est également adapté pour:

15t8/4f/8ccts/em-2pk