EE Lighting SF8-80LED-08 Instructions D'installation

Lighting
READ INSTRUCTIONS AND REVIEW ALL DIAGRAMS BEFORE INSTALLING THE FIXTURE.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CAUTION:
Risk of electrical shock. Make sure the power supply is OFF before installing or maintaining the fixture.
Never perform maintenance or cleaning while the fixture is powered.
Disconnect the power and ensure the fixture is cool before maintaining.
GENERAL:
This product MUST be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is requiring for safety.
ASSEMBLY AND INSTALLATION:
1. Locate the main power and turn it off.(see image 1)
Image 1
3. a. Put the cable through the hole.(see image 3a)
b. Connect the disconnect then ensure the white wire is in the white hole and the black wire is in the black hole. (see image 3b)
c. Connect the ground wire of the power cord to the ground wire of the fixture. Ensure all conductors are fully sleeved and insulated.
Image 3a
Feed main cable through the
grommet in the base tray
4. Hold the fitting up to the ceiling in the desired position.
Secure fixture using supplies and tool appropriate to
the mounting surface (see Images 4a to 4d)
5. Put diffuser back on and tighten screws.
6. Turn on the main power supply and test the luminaire for correct operation.
Black (line)
White (Neutral)
Green (GRD)
Dimming wire 0-10V
Installation Instructions for Stream Flow
SF8-80LED-08(P), SF8-54LED04(P), SF4-40LED04(P),
SF4-40LED02(P), SF3-40LED03, SF2-40LED02
Image 3b
Black Black
White White
Ground Wire Ground Wire
Connect the disconnect
Image 5
WIRING DIAGRAM
LED DRIVER
(optional)
Energy Efficient Lighting Limited | www.eelighting.ca | Tel: 1-855-415-8878
2. Loosen the screw in each side of the lens holder.
Once the screws have been loosened, remove the diffuser.
(see image 2)
Image 4a Image 4b
Mark the screw holes Drill the holes
Restore the main power
• DISCONNECT POWER BEFORE INSTALLING
OR SERVICING.
• ALL ELECTRICAL WORK SHOULD BE
COMPLETED BY QUALIFIED PERSONNEL AND
CAUTION
MEET NATIONAL (NEC), REGIONAL AND
RISK OF
LOCAL ELECTRICAL CODES.
ELECTRIC
SHOCK
Image 2
Image 4c Image 4d
Insert rawlplugs Fit in position
Image 6
EEL17W03