Authentic Models MF200 Instructions

MF200 - 207, 200I -207I Instructions
Important Note:
Place Base Unit in final location desired before assembly. Do not
attempt to move units after stacking as connecting pegs can
become damaged. Disassembly is required before moving units.
Connecting modular units:
All modular unit combinations are held
together by two pegs set into holes on the top
surface of the lower unit. Center upper unit on
top of lower unit, matching holes on upper unit
to pegs below.
For Unit with Doors (MF202, 202I):
Make sure buttons on upper back door panels
are pushed downward to retract locking
mechanisms before assembly.
Set wheels of door panel without handle into
inner track at bottom. Reach behind panel and
push each button upward until locking
mechanism is set into inner track at top.
If door seems too loose or too tight, it may be
necessary to unlock and remove door to adjust
height of wheels. Use a Phillips screwdriver on
screws holding each wheel (turning clockwise to
loosen, counter clockwise to tighten).
Repeat procedure for door panel with handle, using outer track.
Desk parts
4.
MF207, 207I
Pegs
3.
MF206, 206I
2.
MF202, 202I
(or MF201, MF201I)
1.
MF200, 200I
fig. 1
Building a modular desk:
For a standard desk height it is recommended
that you use the following parts:
Set Base in desired location with long brass side facing
Bottom
forward and slat with peg holes on top surface. Stack units for
desk as illustrated (fig. 1), using pegs to hold each lower unit to
upper units.
Peg
Remove the two back brass corners from the lower edge of the
Desk Unit and from the two back upper corners of the unit
Top
below. Two connecting brass corners are provided as a replace-
ment. Screw these into place, securing desk to unit below.
The weight of the Drawer Units (MF204, 204I), when added to
the Desk and the Small Unit (fig. 2), provides additional stability
when using the desk writing surface.
Unit Additions:
A Shelf Unit (MF203, 203I) or up to 3 Drawer Units (MF204,
204I) may be added to the Open Unit (MF201, 201I) (fig. 3).
Four shelf holders are provided for hanging shelf.
Connecting
brass
corner
Completed desk
4.
MF204, MF204,
5.
204I 204I
3.
MF204, MF204,
5.
204I 204I
2.
1.
fig. 2
The Netherlands
AM NL
Ambachtsweg 37
NL-3899 AM
Zeewolde
1. Base Unit (MF200, 200I)
2. Unit with Doors (MF202, 202I)
or Open Unit (MF201, 201I)
3. Small Unit (MF206, 206I)
4. Desk Unit (MF207, 207I)
5. 2 Drawer Units (MF204, 204I)
Open Unit with Shelf or Drawers
MF204, 204I
United States
AM USA
888 Garfield
P.O. Box 21710
Eugene, OR 97402
MF201, 201I
MF203, 203I
MF201, 201I
fig. 3