Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75766F
Wrenches: 12 mm, 17mm, 19mm
Drill Bits: None
Frame Rail
j
Qty. (4)
M12 X 1.25 X 40mm CL10.9
Remove tie down bracket from the driver's side of the vehicle and return to vehicle owner.
1.
2.
Lower exhaust. Remove or reposition exhaust rod. If removed, return to customer. If repositioned, remove bolts, rotate rod to
point forward and reinstall bolts.
3.
Raise hitch into position over existing weldnuts and install the M12 bolts and conical toothed washers as shown above.
4.
Raise and attach exhaust.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2012 Cequent Performance Products, Inc. – Printed in Mexico
Installation Instructions
Toyota RAV4
Fascia
jk
Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft.
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Exhaust Rod
k
½" Conical Toothed Washer
Qty. (4)
Sheet 1 of 3
75766N
Part Numbers:
75766
44686
87631
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
5000 (2267 Kg)
525 (238 Kg)
3500 (1589 Kg)
525 (238 Kg)
Accessory Rating
Remove both M8 fasteners
Muffler
11-20-12
C
Rev. A
Publicité
Manuels Connexes pour Cequent Performance Products 75766
Sommaire des Matières pour Cequent Performance Products 75766
- Page 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. 2012 Cequent Performance Products, Inc. – Printed in Mexico Sheet 1 of 3 75766N 11-20-12 Rev.
- Page 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. 2012 Cequent Performance Products, Inc. – Printed in Mexico Feuille 2 de 3...
- Page 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684 2012 Cequent Performance Products, Inc. – Printed in Mexico Sheet 3 of 3...