Télécharger Imprimer la page

FDI MATELEC FD-020-190 Installation

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

2 WIRE FDI RECEIVER
OVERVIEW
RECEIVER
This receiver has been designed to work with FDI access control systems.
It is compatible with the following dual technology remote controls:
- TM04 (built in 125 kHz tag)
- TELROL (built in Mifare 13.56 MHz tag) / 433 MHz or 868 Mhz depending on the part number
OPERATING MODE
The remotes also have a built in tag (125 kHz or Mifare 13.56MHz).
One benefit of the system is that prox readers return also the same serial number to the controller.
Housing dimensions
IP protection
Wiring
PSU
Loop input
Operating temperature
Frequency
Operating distance
50-001-
/ 433 MHz yellow buttons
blue or grey buttons
91x155x34mm
IP 67
2 wires via the controller (left terminal)
2 wires ( right terminal)
-20° to +60°
433MHz or 868 MHz depending on the part num-
ber
Up to 100 meters in open field
FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France
ACCESSORIES
Remote controls
blue
yellow
868 MHz
433 MHz
Stilus Antenna
grey
www.fdimatelec.com
50-001-650
1

Publicité

loading

Sommaire des Matières pour FDI MATELEC FD-020-190

  • Page 1 2 wires ( right terminal) Operating temperature -20° to +60° Frequency 433MHz or 868 MHz depending on the part num- Operating distance Up to 100 meters in open field 50-001- FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France www.fdimatelec.com...
  • Page 2 Pass the cables through the grommets for a proper sealing. When loop input (B+, B-) is not used, insert the dedicated jump close to the loop terminal. 50-001- FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France www.fdimatelec.com 2...
  • Page 3: Operating Mode

    FD-500-036 : 868 MHz INFORMATION ON UNION HARMONISATION LEGISLATION FDI MATELEC, as a manufacturer, declares under its sole responsibility that the product 2 wire FDI receiver complies with the relevant Union harmonisation legislation : RED 2014/53/EU – CEM 2014/30/EU – ROHS 2011/65/EU This declaration is fully available on request at sales@fdimatelec.com or on our web site www.fdimatelec.
  • Page 4 2 fils - bornier de droite Température de fonctionnement -20° à +60° Fréquence 433 MHz ou 868 MHz suivant référence Distance de réception Jusqu'à 100m en champ libre 50-001- FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France www.fdimatelec.com...
  • Page 5 Passez les câbles par les passes-fils fournis pour protéger de l’eau. L'entrée boucle, lorsqu’elle n'est pas utilisée, doit être shuntée via le pontet fourni. 50-001- FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France www.fdimatelec.com 5...
  • Page 6: Utilisation

    - Antenne optionnelle FD-500-025 (433MHz) ou FD-500-036 (868 MHz) DECLARATION UE DE CONFORMITE La société FDI Matelec, fabricant, déclare sous sa seule responsabilité que le produit récepteur 2 fils FDI est conforme aux législations d’harmonisation de l’Union applicables : RED 2014/53/EU – CEM 2014/30/EU – ROHS 2011/65/EU La déclaration complète est disponible sur demande à...

Ce manuel est également adapté pour:

Fd-020-191