Neptronic STS3-11C Instructions D'installation

Models
STS3-11C(10 KΩ)
STS3-11F(10 KΩ)
STS3-13C(3.3 KΩ)
STS3-13F(3.3 KΩ)
Features
•
Selectable Celsius or Fahrenheit scale
•
Sensor 3.3 KΩ or 10 KΩ
Technical Data
Specification
Description
Scale
Setpoint Range
Sensor NTC
Electrical Connection
Operating Temperature
Storage Temperature
Relative Humidity
Ingress Protection
Weight
Dimensions
A = 3.00" | 78mm
B = 3.00" | 78mm
C = 1.00" | 24mm
D = 2.36" | 60mm
Wiring (Factory Settings)
Mounting Instructions
CAUTION: Remove power to avoid a risk of malfunction.
Remove the captive screw that's holding the base and the front cover of the room setpoint sensor enclosure.
A.
B. Lift the front cover of the enclosure to separate it from the base.
C. Pull wire through the hole in the base.
D. Secure the base to the wall using wall anchors and screws (supplied). Make the appropriate connections.
E. Mount the control module on the base and secure using the screw.
A
B
Recycling at end of life: please return this product to your Neptronic local distributor for recycling. If you need to find the nearest
Neptronic authorized distributor, please consult www.neptronic.com.
STS3-200326
STS3-11C
Can be used with a DF series duct heaters, BM023C actuator, and other Neptronic controllers.
Celsius
14ºC à 30ºC
10 KΩ
Temperature
Sensor
C
D
Specification and Installation Instructions
STS3-11F
Fahrenheit
57ºF à 86ºF
2 wires 0.8 mm 2 [18 AWG] minimum
2ºC to 35ºC (35ºF to 95ºF)
0ºC to 50ºC (32ºF to 122ºF)
5 to 95 % non condensing
IP 30 (EN 60529)
68 g. [0.15 lb]
B
A
P3
Calibration
Potentiometer
P5
TB1
Connecting
Strip
E
Wall Thermostat
Wall Thermostat
STS3-13C
Celsius
14ºC à 30ºC
3.3 KΩ
D
C
STS3-13F
Fahrenheit
57ºF à 86ºF
Page | 1