Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

9" (DE95078F) & 12" (DE95072F) Dock Wheels
IMPORTANT:
DO NOT assemble wheel to mounting bracket before
attaching the mounting bracket to the dock.
Suggested Materials:
• (8) 5/16" x 2" long lag bolts and flat washers
• 1/8" Drill Bit
• Wrench to fit lag bolt
• 2 oz. Waterproof Grease
Installation Instructions:
1. Hold mounting bracket on dock in desired location.
2. Drill 1/8" holes in dock through mounting bracket holes.
3. Screw in lag bolts.
4. Liberally apply grease to mounting bracket post.
5. Place dock wheel over post, using bolt and washers.
6. Tighten bolt securely.
7. Press PVC cap on wheel hub. Cap will slide on more easily
if soaked first in warm water for a few minutes.
8. Inflate to desired firmness. (Do not exceed 3 psi.)
18" (DE95077F) Dock Wheel
IMPORTANT:
DO NOT assemble wheel to mounting bracket before
attaching the mounting bracket to the dock.
Suggested Materials:
• (8) 5/16" x 2" long lag bolts and flat washers and wrench
to fit
• 1/8" Drill Bit
• Wrench to fit lag bolt
• 2 oz. Waterproof Grease
Installation Instructions:
1. Hold the mounting bracket on the dock in the desired
location.
2. Drill 1/8" holes in the dock through mounting bracket
holes.
3. Screw in lag bolts. Liberally apply grease to the mounting
bracket post.
4. Place dock wheel and axle assembly over the mounting
bracket post.
5. Place washer over threaded stud.
6. Thread lock nut on to threaded stud and tighten to locking
position. (Be careful not to overtighten.)
7. Thread the PVC cap on to threaded coupling.
8. Inflate dock wheel to desired firmness. (Do not exceed 3
psi.)
Made and Printed in Canada
v3
300 New Huntington Rd, Woodbridge, ON, L4H 0R4
DOCK WHEELS INSTRUCTIONS
9" & 12" Bracket Assembly
PVC Cap
Retaining Bolt & Washer
Bi-Valve
Dock Wheel
Dock Wheel
and axle
Assembly
PVC Bushing
Mounting Axle
Mounting Bracket Holes
Mounting Bracket
18" Bracket Assembly
PVC Cap
Lock Nut
Washer
Threaded Coupling
PVC Pipe
Bi-Valve
Dock Wheel
Dock Wheel
and axle
Assembly
PVC Bushing
Threaded Stud
Mounting Axle
Mounting Bracket Holes
Mounting Bracket
800-295-3625
www.dockedge.com

Publicité

loading

Sommaire des Matières pour Dock Edge DE95078F

  • Page 1 DOCK WHEELS INSTRUCTIONS 9” (DE95078F) & 12” (DE95072F) Dock Wheels IMPORTANT: 9” & 12” Bracket Assembly DO NOT assemble wheel to mounting bracket before attaching the mounting bracket to the dock. PVC Cap Suggested Materials: Retaining Bolt & Washer • (8) 5/16” x 2” long lag bolts and flat washers Bi-Valve •...
  • Page 2 ROUE DE QUAI - INSTRUCTIONS Roue de quai - 9 po (DE95078F) et 12 po (DE95072F) IMPORTANT: L’ensemble pour roue de quai NE PAS installer la roue sur la bride de montage avant d’avoir fixé la 9 po & 12 po bride de montage sur le quai.

Ce manuel est également adapté pour:

De95072f