Kontour K6023W Guide D'installation

1
ROUGH-IN REQUIREMENTS (see figure 2)
1. Check all items have been received.
1. Towel Warmer
2. Hardwire Kit (plate and tube)
3. Bracket Pack (4 brackets)
2. Your towel warmer requires 110V GFCI protected power. The power feed should be located in a
single gang electrical box as shown in figure 2. Please ensure correct location of the electrical box on
the bottom right, as this will govern your towel warmer location. Do not install towel warmer upside
down.
3. Wall studs or plywood backing is recommended in the wall at all bracket
locations. See figure 2 for bracket locations.
2
INSTALLATION INSTRUCTIONS (see figure 1)
1. Fix wall supports "A" to the wall using the screws provided and in
locations as shown on figure 2.
2. Hang and adjust the towel warmer using set screws "B" to lock stud "C" in
the wall bracket "A". Ensure the towel warmer is firmly and safely fixed.
3
HARDWIRE CONNECTION (see figure 4)
TURN OFF POWER SUPPLY BEFORE PROCEEDING
Do not connect the towel warmer to the power supply until all instructions have been read and
installation carried out in accord with them. Your towel warmer is 90W (110V) and conforms to
CSA standards (File ref: 2422531). Please ensure the CSA label is visible.
1. Feed the electrical cord located at the bottom of the towel warmer first through the round tube then
through the cover plate.
2. Complete all electrical connections as shown in figure 3.
3. Push cover plate onto tube and screw to electric box with the enclosed screws. Adjust where necessary
- see figure 4.
Warning: In case of damage or failure of the towel warmer the unit should be returned to the manufacturer or their distributor. The
warranty of 2 years on the towel warmer is NOT VALID in case of improper use or installation. Product is designed for use within Canada
and the United States only.
Kontour Square Towel Warmer Installation Guide
Code: K6023W / K6024W / K6025W
18" x 40" Hardwire
FIGURE 1
877 757 8930
cs@icobath.com | www.icobath.com