Uline S-21803 Mode D'emploi

π S-21803, S-21804
ONE-WAY MIRROR FILM
TOOLS NEEDED
Film Solution Paper Towel
1. Cover all exposed areas and equipment with drop
clothes to prevent contact with cleaning and film
solutions.
2. Spray entire window with film solution to clean
window. Remove any paint, silicone, adhesive or
residue from window with squeegee.
NOTE: Spraying should be consistent and
overlapping, giving complete coverage for
ample 'slip.' There should be no dry spots on
the glass, which would cause the film to stick
and hamper your ability to slide the film into
position. The film should be easily manipulated
into the proper position.
1. Spray the window.
2. Gently pull the liner off the window film while spraying
the adhesive surface of the film with film solution.
1. Use the hand applicator to accurately trim the film
to fit the window by holding the hand applicator
perpendicular to the window.
2. Cut along the edge of the hand applicator
beginning at the corner and cutting down or across.
NOTE: The hand applicator leaves a 1/16" uniform
space allowing the film to sit smoothly and flat
on the glass without interfering with the frame.
PAGE 1 OF 6
Squeegee Knife
PREPARATION
3. Measure windows to ensure the appropriate width
4. Cut film 2" larger on each side than the size of the
5. Spray window with film solution. Use squeegee to
INSTALLATION
3. Place the window film on the window. Align the film.
4. Once the film is in place, spray a light mist of film
5. Use the squeegee to make horizontal strokes along
6. Pull strokes from the middle outward, stopping a few
7. Absorb excess liquid with paper towel.
TRIMMING/CLEANING
3. Trim each edge of film.
4. After trimming is complete, apply a light mist of
Pour le français, consulter les pages 5-6.
Hand Applicator
and length of film needed.
window.
remove any dust that may have settled.
solution on the window film.
the top of the window to lock the film in place.
inches from each edge.
NOTE: It is important to trim the film before final
squeegee so any dirt beneath the film has a
means of removal.
film solution and perform final squeegee of entire
surface. Pull strokes all the way to the edge of the
film to remove any loose dirt from beneath the film.
Para Español, vea páginas 3-4.
0621 IS-21803