UPM RC420 Manuel Du Propriétaire

DISCONTINUED
RC420+TR310
outdoor remote control set
OWNERS
MANUAL
Cord
Congratulations on your
purchase of a UPM outdoor
remote control set. Please
take the time to read and
understand this manual so
you can begin to enjoy the
LED
convenience this product
Indicator
has to offer.
Learn Key
Learn On/Off
On/Off Key
FEATURES
433 MHz RF technology
Control up to 2 remote
receivers
Heavy duty loading up
to 1800W / 15A resistive
Drip-proof cover design
Transmission range of
up to 30 meters in open
Receiver
area
MOUNTING BRACKET
For safe and optimal performance, use the supplied mounting bracket to hold the
timer vertically and flush against the wall. You will require your own tools and
accessories (i.e. power drill, bits, screws, and/or screwdriver) for proper installation.
WARNING: To avoid shock hazard, timer must be installed vertically and at least 3 ft.
above ground level.
TROUBLESHOOTING
problem solution
Transmitter stops turning receiver Use the LEARN function to
on and off. reprogram the receiver
or
Check the battery.
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules of Operation and is
subjected to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired operation.
TECHNICAL SPECIFICATIONS
Ratings: 120V AC, 15A
Max Load: 1800W resistive; 600W tungsten
Transmission Range: up to 30 meters in open area
Transmission Frequency: 433.92 MHz
http://waterheatertimer.org/Remote-controls-for-home.html
GETTING STARTED
Batteries are not required in the RC420
receiver. Two button cell batteries are
included for the TR310 transmitter.
remove the battery cover from
1
the back of the transmitter
120V 15A Plug
place two button cell batteries
2
between terminals observing
proper polarity, then replace cover
the green LED will light up
3
with any key press once the
battery is installed correctly
Learn On/Off
Transmitter
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the
instructions , may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must
be used with this equipment. Operation with non-approved equipment or
unshielded cables is likely to result in interference to radio and TV reception.
The user is cautioned that changes and modifications made to the equipment
without the approval of manufacturer could void the user's authority to
operate this equipment.
battery installation
3
1
button descriptions
ON/OFF
LED indicator
LEARN - used when
CH 1 - ON
programming receiver
CH 1 - OFF
channel
CH 2 - ON
CH 2 - OFF
LEARN FUNCTION
1
Plug receiver into wall socket
2
Press LEARN on receiver while
simultaneously pressing the desired
channel button on the transmitter
3 1 2
Repeat and for an additional
receiver (available at your local
2
retailer)
4
If LEARN is completed successfully,
the LED on the receiver should light
up when ON is pressed
ON/OFF FUNCTION
1
Power On/Off by using the ON/OFF
keys on the transmitter
2
The ON/OFF button on the receiver
also turns power on and off
2
4
Learn On/Off
3
2
Learn On/Off
1