ACU-RITE 00315 Manuel D'instructions

Congratulations on your new AcuRite product. To ensure the best
possible product performance, please read this manual in its
entirety and retain it for future reference.
1
2
3
Power On
This thermometer includes a "CR-2032"
battery that is already installed. Remove
the plastic insulator tab to activate the
battery and thermometer display.
NOTE that the initial temperature
reading may be higher than the actual
temperature due to the heat from your hands warming up the case
Specifications
TEMPERATURE RANGE -4°F to 158°F
POWER 1 x "CR-2032" (included)
Questions?
Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN
ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR
LOCAL LAWS AND REGULATIONS.
the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of
the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in
fre, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use
rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. Battery contains
mercury. Do not put in trash. Recycle or manage as hazardous waste.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Features & Benefits
1. Suction Cup Mount
Easily mounted on a window.
2. Current Temperature
Displayed in degrees
Fahrenheit.
3. Min/Max
Daily temperature records.
Unpacking Instructions
Remove the protective film
that is applied to the screen
prior to using this product.
Peel off to remove.
BATTERY SAFETY: Follow the polarity (+/-) diagram in
Window Thermometer
models 00315/00316/00317/00318
Replace the Battery
1. Gently squeeze the tabs located at the
bottom of the thermometer to pull out
the battery compartment drawer.
2. Remove and safely discard the old
battery (see disposal safety info
included). Insert a new "CR-2032"
battery, paying close attention to the
polarity markings.
3. Gently insert the battery drawer back
into the thermometer.
Placement
For the most accurate temperature
readings, place your thermometer
in a location that is OUT OF DIRECT
SUNLIGHT. This unit can be mounted on a window using the
included suction cup. For the best performance, clean the area
where you want to adhere the thermometer. Moisten the suction cup
and then press it evenly onto the clean surface.
Occasionally, suction cups will not adhere well in very cold
temperatures. In this case, it may be necessary to re-apply the
suction cup.
MIN/MAX Reset
The MIN/MAX temperature readings will reset every 24 hours. The
reset time is based on when the thermometer was powered on. For
example, if you power on the thermometer at 4:30 PM on Monday,
the MIN/MAX readings will be reset at 4:30 PM Tuesday (24 hours
later).
IMPORTANT
PRODUCT REGISTRATION
Register online
to receive 1 year
warranty protection
www.AcuRite.com
Limited One Year Warranty
At AcuRite, we proudly uphold our commitment to quality technology. Chaney Instrument Co. warrants that all
products it manufactures to be of good material and workmanship, and to be free of defects when properly installed
and operated for a period of one year from the date of purchase.
We recommend that you visit us at www.AcuRite.com for the fastest way to register your product. However, product
registration does not eliminate the need to retain your original proof of purchase in order to obtain warranty
benefts.
Chaney Instrument Co. warrants that all products it manufactures to be of good material and workmanship, and to be free of defects when properly installed and
operated for a period of one year from the date of purchase. Remedy for breach of this warranty is limited to repair or replacement of the defective item(s). Any
product which, under normal use and service, is proven to breach the warranty contained herein within ONE YEAR from date of sale will, upon examination by Chaney,
and at its sole option, be repaired or replaced by Chaney. Transportation costs and charges for returned goods shall be paid for by the purchaser. Chaney hereby
disclaims all responsibility for such transportation costs and charges. This warranty will not be breached, and Chaney will give no credit for products it manufactures
which have received normal wear and tear, been damaged (including by acts of nature), tampered, abused, improperly installed, damaged in shipping, or repaired
or altered by others than authorized representatives of Chaney.
The above-described warranty is expressly in lieu of all other warranties, express or implied, and all other warranties are hereby expressly disclaimed, including
without limitation the implied warranty of merchantability and the implied warranty of ftness for a particular purpose. Chaney expressly disclaims all liability for
special, consequential or incidental damages, whether arising in tort or by contract from any breach of this warranty. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Chaney further disclaims all liability from personal injury
relating to its products to the extent permitted by law. By acceptance of any of Chaney's products, the purchaser assumes all liability for the consequences arising from
their use or misuse. No person, frm or corporation is authorized to assume for Chaney any other liability in connection with the sale of its products. Furthermore, no
person, frm or corporation is authorized to modify or waive the terms of this paragraph, and the preceding paragraph, unless done in writing and signed by a duly
authorized agent of Chaney. This warranty gives you specifc legal rights, and you may also have other rights which vary from state to state.
For in-warranty claims:
Chaney Instrument Co. | 965 Wells St. | Lake Geneva, WI 53147
Instruction Manual
PRODUCT MUST BE REGISTERED
TO RECEIVE WARRANTY SERVICE
►
Register a Product
Printed in China
00315 INST 041414