CARVIN 9413-2012-0050 Guide D'installation

WARNING! READ ! BEFORE INSTALLING
• Install and locate this light in accordance with the installation instructions.
• This light is potentially hazardous if not properly installed.
• This light must be installed in conformance with Article 680 of the Na
tional Electric Code and all local code requirements.
• To reduce the risk of electric shock, a Class A ground fault circuit
interrupter (GFCI) shall be installed in the branch circuit by a licensed
electrician, and all devices in the system must be properly grounded.
DO NOT use extension cord sets.
• The total electrical system must be installed, tested, and approved by
a licensed electrician before it is placed in operation.
water level. The junction box shall be located not less than 8" (20,3 cm) above the pool
water level and not less than 4" (10,2 cm) above the pool deck or ground, whichever is
higher. The junction box shall be located minimum 4 feet (121,9 m) from the perimeter
of the pool, unless separated from the pool by a fence, wall or other permanent
barrier. Junction boxes mounted above grade in the walkway around a pool shall be
Warning : Disconnect all power sources to the pool
equipment before installing this light assembly.
1. Verify that your newly purchased SHW143-PC-1RGB light matches your wattage,
voltage and cord length requirements.
Model IFD Face-Flange Type for LINER pools.
Installation instruction
wall and0.030 inches (0,75 mm) for the liner, and can be mounted before
shipping the pool or panel to the site.
At this point, the pool should be empty with no liner.
Cut a 3-3/8" (86 mm) diameter hole in the required position on the pool wall or
panel, then secure the body (5) through the hole with the spacer lock nut (6)
with water according to the maker's instructions making sure to keep the water level
screws will go. Use the screws to secure the other gasket and the face ring to the body
face ring hole to cut out the liner. Place the light on the deck. Run the end of the cable
down into the pool and into the niche opening. Push the cable into the conduit until it
appears at your wiring junction box. Pull the excess cable through the conduit. Make the
necessary connections as explained on page 2. Finish the installation by screwing the
light in place using the installation tool (7). Add a ¼ turn after you have felt resistance .
M10064C
LIGHT INSTALLATION
INSTALLATION
GUIDE
lOCK NUT
POOL
6
WALL
5
STARLIGHT
9413-2012-(0050,0100,0150)
FIG. A
POOL WALL
SPACER
BODY
FIG. B
LINER
4
3
4
2
FIG. C
No. Description
1 Light (50ft cord)
1 Light (100ft cord)
1 Light (150ft cord)
2 O-Ring
3 Face Flange
4 Gasket
5 Body
6 Spacer Lock Nut
Installation tool
7
LINER
FACE FLANGE
LED
LIGHT
O-RING
SCREW
GASKETS
1
7
Qty Part Number
1 9413-2012-0050
1 9413-2012-0100
1 9413-2012-0150
1 47-0218-03R
1 43-0619-02R
2 13-0870-02R
1 88-3153-00R
1 31-0418-20R
1 23-4980-40
1