Isotek EVO3 TITAN Instructions D'installation

EVO3 TITAN
INSTALLATION INSTRUCTIONS

SAFETY FIRST
PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE INSTALLATION
DO NOT expose this product to dripping or splashing and no objects filled with liquids, such as vases, shall be
placed near the apparatus. If liquid enters the chassis immediately unplug from the wall socket.
DO NOT impede ventilation by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.;
DO NOT expose this product to naked flame sources, such as lighted candles,
these should not be placed near the apparatus;
MAKE SURE that this appliance (CLASS 1) is connected to a mains outlet socket with protective earth.
PLEASE NOTE that the mains plug is used as the disconnect device and must remain readily operable.
OUTPUT SOCKETS
ADDITIONAL INFORMATION ON FUSING AND RATINGS
A
The two output sockets marked 'A' are designed for use with power amplifiers, sub-woofers or active loudspeaker systems.
These sockets are protected by a 16A circuit breaker which can be located under the chassis
B
(B) The output sockets marked 'B' are designed to extend the possible output sockets of the device. This can be used with
the Titan Link cable to connect additional distribution boards.
The rated maximum total load for all
the sockets together (A + B) is 16A 3680W.
SERVICE & REPAIR
NO USER SERVICEABLE PARTS INSIDE
Should the unit fail, or cease to function, or function in a manner which seems unusual, please immediately turn off
and unplug from the mains supply.
Send an email to: support@isoteksystems.com
100-240V ~ 50-60Hz 16A MAX TOTAL
Circuit breaker = 16A
A
Max Total for the two sockets
Mains Power In
and auxiliary 16A 3680Watts
www.isoteksystems.com
Designed in England, hand crafted and assembled in the European Union.
A
Auxiliary Output
DANGER HIGH VOLTAGE
B
Risk of electric shock. No user
serviceable parts inside.
Refer to authorised personnel
for servicing.
SERIAL No.