Télécharger Imprimer la page

Kantech KT-MUL-MT-KP Mode D'emploi

Lecteurs de cartes a puce

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

4.565 [115.95]
0.964 [24.48]
Technical Specifications
Model
RF Technologies
Power Consumption (mA) @
12VDC Peak / AVG
Weight
Capacitive Touch Keypad with
backlighting
Typical Read Range 125 kHz
ioProx ID-1 Credentials (Cards)
Typical Read Range 13.56 MHz
MIFARE Plus EV1, encrypted
sector, ID-1 Credentials (Cards)
Mounting
Dimension in millimeters
(H x W x D)
Dimensions in inches
(H x W x D)
Supported Credentials 125 kHz
Supported Credentials 13.56 MHz
Wiring Terminal
Tamper
Wiegand Communication Formats
Sounder
AES-128 Security
Output
Operating Temperature
Operating Humidity
LED Indicator
Inputs in Wiegand mode
Inputs in RS-485
Input Voltage
Housing
Flammability Rating
Firmware
Ingress Protection Rating
Communication
Cabling
Warranty
Certifications
1
Refer to the installation manual for more details on wiring distances.
Smart card readers / Lecteurs de cartes à puce
Mullion / Meneau de porte
1.770 [44.96]
Front view
Elevation
KT-MUL-MT-KP KT-MUL-MT
13.56 MHz
125 kHz
200 mA / 80 mA 100 mA / 70 mA 100 mA / 70 mA 200 mA / 80 mA 100 mA / 70 mA 100 mA / 70 mA
110 g (0.24 lb) 110 g (0.24 lb) 105 g (0.23 lb)
Yes
Up to 5.1 cm (2")
Up to 3.8 cm (1.5")
115.8 x 44.6 x 24.7
4.56 x 1.75 x 0.97
ioProx and HID®
From the ioSmart card to the reader. From the reader to the access control unit over RS-485
8.5 VDC to 16 VDC (provided by UL listed, power limited power source)
3 twisted pairs AWG 22 unshielded or CAT5, up to 150 m (500')
Front view
Mullion
KT-MUL-SC
13.56 MHz
13.56 MHz
125 kHz
No
No
--
Mullion
--
MIFARE Plus EV1 and ISO/IEC 14443A and 14443B
6 Screwless Poles
Kantech SSF / Kantech XSF / 26-bit / 34-bit
Integrated
RS-485: 1 supervised open-drain, up to 750 mA
- 40 °C to +70 °C (- 40 °F to +158 °F)
0 to 95 % non-condensing
Multi-color bar: Red, green, yellow, blue, configurable
LED and buzzer
2 to 4, configurable
Polycarbonate, smoked black
UL94 V-2
Fully upgradable using RS-485
RS-485 (AES-128) or Wiegand
Limited lifetime
FCC/IC, CE, UL294, NIST, FIPS 197, RoHS, WEEE
D0/
D1/
X-
X+
BUZ/
LED/
I2O
I1
3.254 [82.65]
GND
PWR
Rear view
0.669 [16.99]
Dimensions: Inches [mm]
Single Gang
KT-SG-MT-KP
KT-SG-MT
13.56 MHz
13.56 MHz
125 kHz
125 kHz
175 g (0.4 lb)
170 g (0.37 lb) 165 g (0.36 lb)
Yes
Up to 6.8 cm (2.7")
Up to 4.3 cm (1.7")
Single Gang, North America / Europe
115.8 x 71.5 x 24.7
4.56 x 2.81 x 0.97
ioProx and HID®
Optical
IP55
0.643 [16.32]
KT-SG-SC
13.56 MHz
No
No
--
--
1

Publicité

loading

Sommaire des Matières pour Kantech KT-MUL-MT-KP

  • Page 1 MIFARE Plus EV1 and ISO/IEC 14443A and 14443B Wiring Terminal 6 Screwless Poles Tamper Optical Wiegand Communication Formats Kantech SSF / Kantech XSF / 26-bit / 34-bit Sounder Integrated AES-128 Security From the ioSmart card to the reader. From the reader to the access control unit over RS-485 Output...
  • Page 2 Bornes de câblage 6 pôles sans vis Anti-sabotage Optique Formats de Communication Kantech SSF / Kantech XSF / 26 bits / 34 bits Wiegand Avertisseur sonore Intégré À partir de la carte ioSmart jusqu'au lecteur. À partir du lecteur jusqu'au contrôleur d'accès en Sécurité, cryptage AES-128...
  • Page 3 FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved by KANTECH could void your authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception.
  • Page 4 Note: Use 5.6K for Input 1 and 11.1K for Input 2 / Utilisez 5.6K pour l'entrée 1et 11.1K pour l'entrée 2 © 2017 Tyco Security Products. All Rights Reserved Specifications may change without notice Toll Free: 1-888-222-1560 • Telephone: 1 (450) 444-2030  •  www.kantech.com...

Ce manuel est également adapté pour:

Kt-mul-mtKt-mul-scKt-sg-mt-kpKt-sg-mtKt-sg-sc