Cooper Lighting Solutions Lumark Axcent Small Instructions D'installation

IB514031EN
Installation Instructions – Axcent (Small & Large)
Instructions d'installation – Axcent (petit et grand)
Instrucciones de instalación – Axcent (pequeño y grande)
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the
product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Refer to product label for specific minimum supply conductor requirements.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
N ote: These instructions do not claim to cover all details or variations in the equipment, procedure, or process
described, nor to provide directions for meeting every possible contingency during installation, operation
or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for
user's purpose, please contact your nearest representative.
N ote: Care must be taken not to set lighting fixture down on optical lenses or lift the fixture in the lens area.
N ote: Specifications and dimensions subject to change without notice.
If the light fixture is ordered with the CBP (Cold Weather Battery Pack) option, then "this luminaire is
N ote:
provided with a factory installed emergency lighting pack and must be serviced by a person familiar with
the construction and operation of product and hazards involved" .
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind
that may arise from the improper, careless, or negligent installation, handling or use of this product.
NOTICE: Green ground wire provided in proper location. Do not relocate.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on
delivery receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be
filed within 15 days of delivery. All damaged material, complete with original packing must be retained.
Safety: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting use, and should not be used in area of
limited ventilation or inside high ambient temperature enclosures. Not suitable for indoor use when installed in
inverted/uplight orientation.
NOTE: When the fixture is facing upward where debris may accumulate, add a wire guard or vandal shield as
needed to prevent debris from overheating the lens and/or the fixture.
NOTE: Fixture must be stored in a dry location before installation. Do not expose lighting fixture to rain, dust or
other environmental conditions before installation and insertion of photocontrol or shorting cap (if so equipped).
Best results will be obtained if installed and maintained according to the following recommendations.
WARNING
Brand Logo
reversed out of
black Lumark
INS # INS #