H-12573
KEURIG
K-SUITE
®
COMMERCIAL BREWER
OPERATING ISSUE
Grounds in coffee.
Brewer will not brew.
Brewing as partial cup.
Brewer does not have
power or shuts off.
PAGE 1 OF 6
1-800-295-5510
uline.com
TROUBLESHOOTING
CAUSES
Grounds may have gathered in the
exit or entrance needles and can
be cleaned using a straightened
paper clip or similar tool.
A minimum of 6 oz. of water is
required to brew.
Brewer may need to be restarted.
The exit needle may be clogged.
The brewer may need to be
descaled
Brewer is not turned on.
The electric circuit is overloaded.
NOTE: For energy savings,
the brewer automatically
turns off 90 seconds after
the last brew.
Pour le français, consulter les pages 5-6.
RECOMMENDATIONS
Clean the exit needle of the K-Cup
holder. Refer to exit needle care on page 6
of the instructions.
Clean the brewer entrance needle. Refer
to entrance needle care on page 6 of the
instructions.
Add an additional 2 oz. of water to the
reservoir to ensure the minimum fill level has
been met, then press the BREW button. Repeat
until the brewer begins to dispense.
Press the POWER button. Press and hold the
brew button for 5 seconds until all the water
has been dispensed. Discard the contents into
the sink. Press the POWER button to restart.
Refer to the exit needle care on page 6 of the
instructions.
If you have repeated the descale procedure
on your brewer two times and it is still only
brewing a partial cup, contact Uline Customer
Service at 1 800 295-5510.
Press the POWER button.
Plug brewer into its own grounded outlet. If
the electric circuit is overloaded with other
appliances, your brewer may not function
properly. The brewer should be operated on its
own circuit, separate from other appliances.
Press the POWER button to restart.
If the brewer still does not have power, contact
Uline Customer Service at 1 800 295-5510.
Para Español, vea páginas 3-4.
pod
®
0226 TH-12573