Eaton LD06P Guide

Eaton Dimmer
3-Way Wiring
Instructions
Setup Guide
LD06P - Decorator Dimmer
LS06P - Slide Dimmer
Scan QR code
for product
information.
EIS-0314-EFS (REV. A)
Prepare
1.
Shut off circuit breaker before installation.
ON
OFF
2. You will need:
Included in box:
Not included in box:
Voltage tester
or
Screwdriver
LD06P LS06P Decorative Wire nuts
Dimmer Dimmer wallplate
Additional information
WARNINGS AND CAUTIONS
• Turn OFF circuit breaker/remove fuse(s) and test if power is OFF before
installation
• Never wire any electrical device with power ON
• Contact a licensed electrician if you are unsure about any part of these
instructions
• The device may not work or may be damaged if wired incorrectly, or wiring
with power ON. Warranty may be voided.
• CAUTION: To reduce the risk of overheating and possible damage to this
device or other equipment, do not install to control a receptacle, motor-
operated appliance, or a transformer-supplied appliance.
• Contact a licensed electrician if bare copper or green ground connection
are not present in wall box.
• Use only #14 or #12 copper wire rated for at least 75°C. DO NOT USE
ALUMINUM WIRE
• Use only with 120V/AC 60Hz and with permanently installed fixtures
• Do not exceed maximum rating indicated on the device
• Must be installed and used in accordance with all national and local
electrical codes
• Outlet box must be at least 3" x 2" x 2-1/2" and wired in accordance with
NEC article 314 box fill requirements
Check
3. Remove wallplate and unscrew old device.
• Make sure the power is off using voltage tester,
non-contact voltage tester, or multimeter.
Warning! Risk of injury
(See Fig. 1 below)
or death. Contact an
• If power is still on, there might be another circuit
electrician if you are
unsure about any part
breaker powering this terminal. Switch terminal off
of these instructions.
and retest.
Fig. 1
4. Indentify GROUND, NEUTRAL (if present),
TRAVELERS, and COMMON/HOT wires for
future use.
GROUND
NEUTRAL
TRAVELERS
HOT/COMMON
2"
2.5"
3"