Publicité
3 - PRACTICAL OPERATING ADVICE
3.4
USE OF SUPPORTS (runners, modules and trolleys)
3.4.1
SUSPENDED RUNNERS
» Prepare the oven and check the following points:
✓
Remove all trays, plates and grids from the cooking cavity.
✓
The core probe has been removed from its housing.
✓
The USB core probe is not in the cooking cavity.
»
Lift the runner slightly by the middle of one of the upper levels .
» Tilt the runner towards the centre of the oven to release it from its lower supports (rear and front).
.
» Remove the runner from its upper supports (front and rear) .
» Remove the runner from the cooking cavity .
3.4.2
TROLLEYS WITH RUNNERS OR BANQUETING
»
Remove suspended runners by following the instructions in the "Suspended runners" paragraph.
»
Position the banqueting running frame at the bottom of the oven cavity.
» Move the table fitted with the runners or Banqueting trolley in front of the oven. Make sure the
trolley is locked to the table during transport .
» Position the table in front of the oven and unlock the trolley.
» Push the runners or Banqueting trolley onto the banqueting running frame.
Caution : Push the trolley all the way into the cavity before closing the oven door.
3.5
POSITIONING AND STORAGE OF THE CORE PROBE
The oven is supplied as standard with a core probe connected to the inside of the cooking cavity. Please follow the instructions below on the use and
position of the probe. As an accessory, you can purchase a USB core probe that can be connected to the USB socket.
CHEF'SCOMBI
1
When handling the core probe, CAUTION it may be very hot. Use protection when
removing/handling the probe if it is hot.
When handling the probe, CAUTION you could injure yourself with the tip. Handle the probe
with care and always grasp it by the handle.
Do not place the core probe behind the ventilation panel, as this could damage the sensor in the
turbine, on the heating element or on the gas exchanger.
When not cooking, do not leave the probe in the bottom of the oven or hanging outside the cooking
cavity, as the probe could be damaged. Store the probe in the holder provided on the left runner or
disconnect it if the core probe is connected to the external USB socket.
Page 8 / 161
EN
3V-490099EU – 04/25
Publicité
