Atomic Hi Feel Pro PSP Mode D'emploi page 4

PACKAGE CONTENTS:
- Main speaker unit Hi Feel PRO PSP Atomic.
- 3.5mm cable compatible with audio
device from 3.5V.
- Protective case.
- 4 AAA batteries.
- User's manual.
HI FELL PRO PSP ATOMIC
INSTRUCTIONS:
1. When using the Hi Fell PRO PSP
Atomic for traveling, remove the
battery lid and insert 4 AAA batteries
(included in the box). Replace the
battery lid.
2. For use where there is a wall-outlet,
simply use your PSP
power cord and plug it in to the DC
input jack on the ISound.
NOTA: when using a power cord, the
tm
PSP system will charge while sitting
in the speakers' base.
3. Separate the speakers by carefully
sliding the right speaker out to the
right and left speaker out to the left
simultaneously until they are fully
extended.
4. Place your PSP
the 2 speakers. Make sure to line-up
the stems (power and sound) with
the corresponding input of your PSP
system. Once you have lined up the
tm
compatible
tm
system in-between
connectors, simply push your PSP
system onto the base. Make sure the
tm
PSP system is firmly seated on the
speakers' base.
5. To power on your PSP
press the power button on the Hi
Feel PRO PSP Atomic. You are now
ready to enjoy your Hi Feel PRO PSP
Atomic. For a truly sensational audio
experience!
6. You can adjust the volume, add "bass"
and "surround" sound effects by using
the dial and buttons located on the
front of the Speaker System base.
7. The Hi Feel PRO PSP Atomic are also
compatible with any audio devices
that have a 3.5v. output. Simply
connect the cable included in the
box to your audio devices' audio
output and connect the other end to
the Hi Feel PRO audio input. You can
also connect external speakers using
the Hi Feel PRO PSP Atomic audio
output port.
TROUBLESHOOTING
Problem: Hi Feel PRO will not turn on?
Solution: Confirm PSP
System is powered on.
Solution: Replace batteries or confirm
Hi Feel PRO Speakers is plugged into
tm
a wall-outlet.
tm
tm
system and
tm
and Speaker