Product Configuration; Setup; Tdf/Dcf Setup; Gps Or Afnor Setup - Gorgy Timing RADIO TIMING NETWORK Mode D'emploi

1.3. PRODUCT CONFIGURATION

1.3.1. SETUP

A. TDF/DCF Setup
The product is automatically configured.
The transmitter must receive a correct information from the DCF or TDF antenna.
Then the information are transmitted to the receivers during 4 minutes.
This functioning cycle is repeated at each correct TDF or DCF data reception.
B. GPS or AFNOR Setup
The product is automatically configured.
The transmitter must receive a correct information from the GPS antenna or AFNOR
input. Then the information are transmitted to the receivers.
This functioning cycle is repeated at each correct GPS or AFNOR data reception.
► Time zone and time difference configuration:
N° SWITCH
1
2
3
4
5
6
7
8
20
1
2
Time difference in BCD format
4
8
10
Sign of the time difference
«-» if set to on, «+» if set to OFF
Continuous transmission if set to «ON» =TEST MODE
(No GPS Synchronization)
Summer/Winter changeover if set to «ON»
MEANING
MDE-RTnetwork-3076V1.2