Prokonian SP2315-IR-PHRM Manuel D'instruction page 5

SAFETY INFORMATION
Electrical Connection
• A 15-amp, 120-volt, 60 Hz circuit with a properly grounded outlet is
required. Preferably, the fireplace will be on a dedicated circuit as other
appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation. The unit comes
standard with 6-ft. three-wire cord, exiting from the rear of the
fireplace. DO NOT exceed the current rating of the current tap. ALWAYS
plug heaters directly into a wall outlet/receptacle. NEVER use with an
extension cord or relocatable power tap (outlet/power strip).
• This heater is for use on 120 volts. The cord has a plug as shown
below. See illustration for grounding instruction. An adapter as shown
at C is available for connecting three-blade grounding type plugs to
two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a three-slot
grounded receptacle is available.
SAVE THESE INSTRUCTIONS
All manuals and user guides at all-guides.com
ELECTRICAL SPECIFICATIONS
Voltage: 120 VAC, 60 Hz
Amps: 12.5 Amps
Watts: 1500 Watts
Metal
Screw
Cover of
Grounding
Grounding Pin
Box
A B
C D
Grounding Means
Adapter
Grounding Pin
4