Télécharger Imprimer la page

Zodiac Z250 MD3 Notice D'installation Et D'utilisation page 47

Pompe à chaleur

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
2.4.5 Adjusting the temperature setpoint
• Unlock the keypad : the main menu is displayed.
• Check that the compressor is working : the
and "2.2.1 Mode details" to choose an operating mode and activate the compressor.
is displayed. Press
• SET
• When the setpoint temperature is reached, the heat pump stops heating/cooling the water. Then, the
heat pump automatically regulates the pool water temperature (independant to the chosen mode).
• The heat pump runs again to reach out the setpoint when there is a gap of 2°C between the pool water
temperature and the setpoint water temperature.
• Example: the setpoint temperature is 25°C and the pool water temperature has reached it. The heat pump
stops.
- In cooling mode, the appliance will automatically run again if the pool water temperature is higher
than 27°C.
- In heating mode, the appliance will automatically run again if the pool water temperature is lower
than 23°C.
• If heating priority is not activated, the heat pump waits for the next filtration pump cycle to run.
2.4.6 Deactivating the operation of the heat pump
It may be necessary to deactivate the operation of the heat pump, for maintenance purposes for example. In this case,
the user interface (screen) remains powered. To deactivate the operation of the heat pump :
• Unlock the keypad: the main menu is displayed.
• Press
for 2 seconds. The heat pump's compressor will stop after few minutes : the
the compressor isn't working.
• Make sure to switch the compressor on again by pressing
the heat pump.
icon must be displayed, see "2.4.4 Choosing an operating mode"
and
to modify the temperature setpoint.
for 2 seconds to guarantee the normal operation of
EN
icon disappears when
16

Publicité

loading

Ce manuel est également adapté pour:

Z250 md4Z250 md5Z250 md6