Zodiac Z250 MD3 Notice D'installation Et D'utilisation page 33

• Deactivating, eliminating or by-passing any of the safety mechanisms integrated
into the appliance shall automatically void the warranty, in addition to the use of
spare parts manufactured by unauthorised third-party manufacturers.
• Do not spray insecticide or any other chemical (inflammable or non-inflammable)
in the direction of the appliance, as this may damage the body and cause a fire.
• Do not touch the fan or moving parts and do not place objects or your fingers in the
vicinity of the moving parts when the appliance is in operation. Moving parts can
cause serious injury or even death.
WARNINGS ASSOCIATED WITH ELECTRICAL APPLIANCES
• The power supply to the appliance must be protected by a dedicated 30 mA Residual
Current Device (RCD), complying with the standards and regulations in force in the
country in which it is installed.
• The equipment not include electrical switch for disconnection; include a
disconnection supply device in the fixing wiring at least OVC III, in accordance
applicable national laws.
• Do not use any extension lead when connecting the appliance; connect the
appliance directly to a suitable power supply.
• Before carrying out any operations, check that:
- The required input voltage indicated on the appliance information plate
corresponds to the mains voltage;
- The mains supply is compatible with the appliance's electricity needs and is
correctly grounded.
• In the event of abnormal operation or the release of odours from the appliance,
turn it off immediately, unplug it from its power supply and contact a professional.
• Before servicing or performing maintenance on the appliance, check that it is
powered off and completely disconnected from the power supply. Moreover,
check that the heating priority (where applicable) is deactivated and that any
other device or accessory connected to the appliance is also disconnected from
the power supply.
• Do not disconnect and reconnect the appliance to the power supply when in
operation.
• Do not pull on the power cord to disconnect it from the power supply.
• If the power cord is damaged, it must be replaced by the manufacturer, an
authorised representative or a repair facility only.
• Do not perform maintenance or servicing operations on the appliance with wet
hands or if the appliance is wet.
• Before connecting the appliance to the power supply, check that the connection
unit or socket to which the appliance will be connected is in good condition and
shows no signs of damage or rust.
• In stormy weather, disconnect the appliance from the power supply to prevent it
from suffering lightning damage.
• Do not immerse the appliance in water or mud.
WARNINGS CONCERNING APPLIANCES CONTAINING R32 REFRIGERANT
• This device contains R32 refrigerant, a class A2L refrigerant, which is considered to
be potentially flammable.
• Do not discharge R32 fluid into the atmosphere. This is a fluorinated greenhouse
gas, covered by the Kyoto Protocol, with a Global Warming Potential (GWP) = 675
(European regulation EU 517/2014).
• In order to comply with the applicable standards and regulations in terms of the
environment and installation, in particular Decree No. 2015-1790 and/or European
regulation EU 517/2014, a leak test must be performed on the cooling circuit when
the appliance is first started and at least once a year. This operation must be carried
out by a specialist certified to test cooling appliances.
• Install the unit outdoors. Do not install the unit indoors or in an enclosed, non-
ventilated area.
EN
2