Télécharger Imprimer la page

Velleman VTLLAMP2W Mode D'emploi page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Do not stare directly at the light source, as this may cause
Keep away from excessive heat and direct sunlight.
The housing might heat up during usage. Keep minimum distances around the
device for sufficient ventilation. Place the device on a flat, heat-resistant surface. Do
not place the device on carpets, fabrics...
Where the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
If the external flexible cable or cord of this luminaire is damaged, it shall be
replaced by a special cord or cord exclusively available from the manufacturer or his
service agent.
Never leave the magnifying lens unattended where direct sunlight may pass through
it: this creates a fire hazard. Close the lens cover after use.
3.
General Guidelines
Refer to the Velleman
manual.
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
Nor Velleman Group nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
Keep this manual for future reference.
4.
Installation
1.
Open the table clamp by twisting the T-handle counter clockwise.
2.
Slide the clamp over a suitable and solid horizontal surface capable of carrying it,
T-handle at the bottom.
3.
Twist the T-handle clockwise until the clamp is firmly secured to the surface.
4.
Slide the stem of the lamp into the hole on top of the clamp.
5.
Plug the power cable into a suitable mains outlet.
6.
Switch on the lamp with the on-off button on top of the lamp.
7.
The magnifying lens is protected by a hard cover. Fold it upwards to use the lens.
Do not force. Always close it when not in use to avoid fire hazard (sunlight).
Optional (not incl.):
stand with wheels: VTLAMPST
table stand: VTLAMPST1
V. 04 – 14/06/2022
epileptic seizure in sensitive people
o
temporarily loss of sight (flash blindness)
o
permanent (irreversible) eye damage.
o
®
VTLLAMP2W
Service and Quality Warranty on the last pages of this
3
©Velleman Group nv

Publicité

loading