Flip Mode:
Press once and you will hear one beep - you are in Regular
Mode. Press again and you will hear two beeps - you are
now in Flip Mode.
In Flip Mode you can use the RIGHT control stick to flip
forwards or backwards and to flip left or right.
Stunt Flip forward/backward:
Users can do a forward flip with the FOCUS by pressing
the Flip button and moving the right stick UP
simultaneously. To flip backwards, press the Flip button
and move the right stick DOWN simultaneously. Make
sure you do flips in a large, unobstructed space!
Stunt Flip left/right:
Users can do a left flip with the FOCUS by pressing the
Flip button and moving the right stick LEFT
simultaneously. To flip right, press the Flip button and
move the right stick RIGHT simultaneously. Make sure
you do flips in a large, unobstructed space!
Orientation Control:
allows directional override
Auto Return:
By pressing the Auto Return button, the quadrocopter will
return to the controller location. make sure there are NO
obstacles between the toy and the controller.
How to charge the Litehawk FOCUS:
Battery and Charger
To reduce the overall cost of using your new toy both the Controller and Drone comes with
a rechargeable battery and a USB charger. You should expect 5-8 min run time. However
you do need to make sure to properly maintain your Li-Po Battery.
- Li-Po batteries don't like to be run down too low. If the voltage is dropped dramatically
they will be damaged and will not recharge! Once the model starts to slow (or the battery
level indicator on the screen reads low), drive your model to a safe place, walk over and
turn it off.
- It is recommend to charge the battery after your run and to always store the battery with
a charge. Never discharge or dead short a Li-Po battery!
- Always have your model battery unplugged and controller turned off and unplugged when
not in use.
Charging:
1. Insert the battery into the USB charger.
2. Plug the USB Charger into a USB port (TV, Computer, etc.)
3. The USB charger led lights up in red when charging. Once the battery is fully charged,
the led goes out. The battery takes about 30 minutes to charge.
Installing the battery
After fully charging your batteries you can then insert them into your Controller and
Drone.
Controller
1. Unscrew the battery door on the back side of the Controller.
2. Plug the Controller battery into the controller. This plug is keyed and only goes in one
way.
3. Re-install the battery door.
instal all
l
t
th
e ba
a
tt tter ery
y
y
door or.
do
.
www.litehawk.ca
R