Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

VR9205Q
Direct Ignition Combination
2-Stage Gas Controls
APPLICATION
The VR9205Q Direct Ignition Combination 2-Stage Gas
Controls are used in gas-fired appliances with up to 140
KBtu/h capacity at 1 in. wc pressure drop. They have
been optimized for direct ignition applications and include
Size Inlet-
Model
Outlet (in.)
VR9205
1/2 x 1/2
a
Capacity based on 1000 Btu/ft
at 0.25 kPa pressure drop).
b
Minimum regulation rated at high fire. Low fire regulation minimum based on outlet pressure is approximately 8 KBtu/h.
Table 2. Model Number Suffix Letter Designation.
Model Number
Suffix Letter
Q
SPECIFICATIONS
Body Pattern: Straight through; see Table 1 for inlet and
outlet size.
Electrical Ratings:
Voltage and Frequency: 24 Vac, 50/60 Hz.
Current Draw: Low Stage energized, 0.4A; High Stage
energized, 0.5A.
Capacity: See Table 1.
Regulation Range: See Table 1.
Table 3. Natural-LP Gas Conversion Kits.
Model Number Suffix
Letter
Q
Table 1. Valve Capacity.
AGA Certified
Capacity
KBtu/h
140
3
, 0.64 sp gr natural gas at 1 in. wc pressure drop (37.3 MJ/m
Ambient Temperature
Range
-40°F to 175°F
(-40°C to +79°C)
Kit to Convert Natural
Gas to LP
50033841
INSTALLATION INSTRUCTIONS
a manual switch, two automatic operators and a pressure
regulator. The valve may be used on either natural gas or
LP gas applications.
• Valve capacities are shown in Table 1.
• For suffix letter designation, see Tables 2 and 3.
a
AGA Certified Minimum
b
Regulation
KBtu/h
20
Pressure Regulator
Type
Two-Stage
Natural-LP Gas Conversion Kits: See Table 3.
6 in. Wire Harness: 50045486-001.
Gas valve end: Tyco Mate-N-Lok consisting of the
following:
Housing: Tyco 172166-1.
Pins: Tyco 770904-1 or 770988-1.
Control end: 3/8 in. stripped leads.
Approvals:
CSA Design Certificate # 158158
Kit to Convert LP to
Natural Gas
50033842
AGA Certified Maximum
Regulation
KBtu/h
200
3
, 0.64 sp gr natural gas
Place Bar Code Here
69-2143EF—01

Publicité

loading

Sommaire des Matières pour Honeywell VR9205Q

  • Page 1 2-Stage Gas Controls INSTALLATION INSTRUCTIONS APPLICATION The VR9205Q Direct Ignition Combination 2-Stage Gas a manual switch, two automatic operators and a pressure Controls are used in gas-fired appliances with up to 140 regulator. The valve may be used on either natural gas or KBtu/h capacity at 1 in.
  • Page 2 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS PLANNING THE INSTALLATION Dust or Grease Accumulation WARNING Heavy accumulations of dust or grease can cause the control to malfunction. Where dust or grease can be a Fire or Explosion Hazard. problem, provide covers for the control to limit Can cause property damage, severe injury, contamination.
  • Page 3 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS Location CAUTION The gas controls are mounted in the appliance vestibule on the gas manifold. If this is a replacement application, Equipment Damage Hazard. mount the gas control in the same location as the old Can burn out thermostat or transformer.
  • Page 4 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS DROP Table 4. NPT Pipe Thread Length. PIPED HORIZONTAL CONTROL Thread Pipe Maximum Depth Pipe can SUPPLY Pipe Size This Amount be Inserted into Control RISER 9/16 CONTROL PIPED 3 IN. All dimensions are in inches.
  • Page 5 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS Wiring Typically Connects to Valve Pins (through Mini Mat-N-Loc) WARNING Low Stage Mv, Lo, Valve Electrical Shock Hazard. High Stage W2, Hi Can cause severe injury, death or property Common MV/Pv, Valve, Common damage.
  • Page 6 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS Turn On System 6. After high pressure has been checked, check low pressure regulation. Two-stage appliance operating Push the on-off switch to the ON position. sequences vary. Consult the appliance manufacturer’s instructions for the specific...
  • Page 7 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS SERVICE 4. Time the length of spark operation. See the DI module specifications. 5. After the module locks out, enable the on-off switch and make sure no gas is flowing to the main burner.
  • Page 8 VR9205Q DIRECT IGNITION COMBINATION 2-STAGE GAS CONTROLS IMPORTANT 5. Wait five minutes to allow any gas in the Follow the operating instructions provided by combustion chamber to vent. Then if you smell the heating appliance manufacturer. The gas, STOP! Follow Step 1 in the Warning above. If information below describes a typical control you do not smell gas, continue with the next step.
  • Page 9 Les régulateurs à gaz combinés à deux étages à de pression. La vanne peut être utilisée sur les allumage direct VR9205Q sont utilisés dans les appareils applications à gaz naturel ou GPL. à gaz d’une capacité de 140 KBtu/h max. avec chute de •...
  • Page 10 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT PRÉPARATION DE L’INSTALLATION Accumulation de poussière ou de AVERTISSEMENT graisse Risque d’incendie ou d’explosion. Des accumulations importantes de poussière ou de Peut causer des dégâts et des blessures graisse peuvent causer le dysfonctionnement du graves, voire mortelles.
  • Page 11 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT Emplacement MISE EN GARDE Les régulateurs à gaz sont montés sur le vestibule de l’appareil sur le collecteur de gaz. S’il s’agit d’une Risque de dégât matériel. application de rechange, monter le régulateur à gaz au Le thermostat ou le transformateur peuvent même emplacement que l’ancien régulateur.
  • Page 12 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT Tableau 4. Longueur de filetage de tuyau NPT. CANALISATION DESCENDANTE Dimension Filetage du Profondeur maximale RÉGULA- ALIMENTATION PAR de la conduit à d’insertion du tuyau HORIZONTAL TEUR TUYAU RIGIDE...
  • Page 13 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT Câblage Broches de Se connecte généralement à (via AVERTISSEMENT vanne le dispositif Mini Mat-N-Loc) Étage inférieur Mv, Bas, Vanne Risque de choc électrique. Étage supérieur W2, Haut Peut causer des dégâts et des blessures graves, voire mortelles.
  • Page 14 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT 4. Avec le brûleur principal allumé, badigeonner les 1. Régler l’appareil sur combustion élevée. joints du tuyau (y compris les douilles) et l’entrée et 2. Vérifier avec soin l’allumage du brûleur principal.
  • Page 15 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT Tableau 5. Spécifications des pressions du régulateur de pression (po c.e.). Type de Plage de pression Pression de sortie Modèle d’entrée nominale nominale réglée en usine Plage de réglage Deux étages...
  • Page 16 VR9205Q RÉGULATEURS À GAZ COMBINÉS À DEUX ÉTAGES À ALLUMAGE DIRECT Si le brûleur principal ne s’allume pas IMPORTANT Suivre les instructions de fonctionnement avec l’appel de chaleur fournies par le fabricant de l’appareil de 1. Confirmer que le bouton du régulateur est sur chauffage.