Akrapovic Slip-On Instructions D'installation page 9

INSTALLATION OF THE AKRAPOVIČ EXHAUST SYSTEM:
Correctly position the carbon-fiber clamp and slide it onto the muffler - bear in mind the right offset of the carbon
1.
fiber- clamp; check the correct position of the yellow sticker on the clamp (F 03).
IMPORTANT: open the clamp slightly wider than the diameter of the outer sleeve of the muffler – do not
scrape it along the muffler outer sleeve!
Correctly orient and install the clamp and insert the graphite gasket into the muffler's inlet pipe (F 04).
2.
CAUTION: make sure not to damage the gasket or any other part of the exhaust system during this procedure!
9 / 16
F 03
F 04