Figure C – DEGARDO
The planter inserts and decorative inserts make it easy to change the planting or use of the product
and allow easy access to change a bulb. Inserts are available as accessories.
Figure C – Planter insert and decorative
Planter insert item no.
Decorative insert item no. 227607
Planter insert item no.
Dekoeinsatz Art.-Nr.
Notice: The drill must be kept perpendicular to the surface being drilled through. Otherwise
irreparable damage may be caused.
Set-up (illuminated products)
The products are supplied ready for connection. Insert the power plug into the socket.
Operating products with LED RGB+CCT - Illumination with the remote control
Pairing and unpairing the remote control
The remote control is paired to the light in the factory. If the light does not respond to the remote
control, pairing must be carried out again. Follow these steps to do this:
1. Remove the plug from the socket for a short while then replace it.
2. Within 3 seconds, press one of the zone buttons POWER-ON (F10) 3 times in quick succession.
3. If pairing was successful, the light will flash green 3 times.
If the light does not flash, repeat the process.
If one light zone needs to be unpaired from the remote control, proceed as follows:
1. Remove the power plug from the socket for a short while then replace it.
2. Within 3 seconds, press the required zone button POWER-ON (F10) 5 times in quick
succession.
3. If unpairing the zone has been successful, the light will flash red 10 times.
Notice: any number of lights can be operated using the remote control. A maximum of 4 zones can be
allocated to one remote control. Take care to ensure that the lights within any one zone are not more
than 10 metres apart.
TREVIA | STORUS | VARIA | ROVIO
®
planter insert and decorative insert
TREVIA I
TREVIA II
183915
183913
227610
TREVIA 900K
STORUS V
183909
227674
227631
227675
www.degardo.de
TREVIA III
TREVIA IV
183911
193831
227613
227616
VARIA
ROVIO III
231343
205679
231344
227638
TREVIA V
227627
DE
227628
ROVIO IV
GB
210784
227641
FR
21