Ruby Fires 1717 Mode D'emploi Et Consignes De Sécurité page 8

installation oF the log set/peBBles
• Ruby Fires has developed a special ceramic log set and pebbles for decoration purposes of
the ceramic burner. Place these around the fi re opening (the (white) ceramic element) of the
burner. the fi re opening should remain free. When decoration material is placed into the flames,
unnecessary soot will be formed and an unsafe situation may arise. Do not touch
decoration material until it has cooled down for at least 30 minutes. Risk of burns!
• For safety reasons never use any other decoration material for the ceramic burner except the
original Ruby Fires ceramic log set or pebbles. Do not use both the log set and/ or pebbles at the
same time with the glasses. Risk of fire! When placing a ceramic burner against a back wall (e.g.
(wall)surround), make sure the flames burn vertically at all times. this by using glass, log set,
pebbles or a spoiler. In case the flames do hit the back, extinguish the fire immediately and
contact your supplier! Check our website for different examples.
Filling the ceramic Burner with ruBy Fires cl100
• use only CL100 to fill the ceramic burner.
• It is of great importance that the liquid never flows outside the filling opening.
• Make sure to fill the ceramic burner carefully and slowly, so it cannot be overfilled.
• In case liquid is spilled, use a soft, absorbing cloth to clean.
• For an optimal fire the burner has to be filled up until the liquid remains visible in the opening.
When the ceramic burner is filled with CL100 for the first time, the ceramic element on the inside
will be saturated completely. the liquid will always remain partly absorbed by the brick. therefore
it is necessary to use more bio ethanol the first time the burner is filled than the following times.
Burner
Ceramic burner Enna (1717B)
Ceramic burner Mini (4114)
Ceramic burner Small (4120 + Silo) ± 1,5 liter
Ceramic burner Big (5820)
Ceramic line burner (8014)
Ceramic line burner (11814)
how to Fill the ceramic Burner
• Open the latch for one third, so the filling-opening is visible. With square burner: open fully.
• Place the enclosed funnel in the filling-opening.
• Carefully pour the Ruby Fires bio ethanol in the funnel until the ceramic brick is saturated,
but make sure that the liquid level remains underneath the surface of the element: until the
liquid remains visible in the opening and is not higher than the MAX sign.
WARNING: Make sure that the liquid does not flow outside the filling-opening. In case liquid has
been spilled outside the filling-opening, make sure this is dried up before lighting the fire.
Risk of fire! there should never be fire outside the fire-opening. this is dangerous and can also
cause the insert to de-form and damage of the paint of the insert.
first filling
± 0,8 liter
± 1 liter
± 2 liter
± 2,5 liter
± 3,5 liter
refill
± 0,6 liter
± 0,8 liter
± 1 liter
± 1,5 liter
± 2 liter
± 2,5 liter